M16C26A Datasheet, PDF (100/352 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/Tiny SERIES

M16C/26A Group (M16C/26A, M16C/26B, M16C/26T)
11. DMAC
Table 11.1 DMAC Specifications
Item
Specification
No. of channels
2 (cycle steal method)
Transfer memory space
• From any address in the 1M bytes space to a fixed address
• From a fixed address to any address in the 1M bytes space
• From a fixed address to a fixed address
Maximum No. of bytes transferred
DMA request factors ^{(1, 2)}
128K bytes (with 16-bit transfers) or 64K bytes (with 8-bit transfers)
________
________
Falling edge of INT0 or INT1
________
________
Both edge of INT0 or INT1
Timer A0 to timer A4 interrupt requests
Timer B0 to timer B2 interrupt requests
UART0 transfer, UART0 reception interrupt requests
UART1 transfer, UART1 reception interrupt requests
UART2 transfer, UART2 reception interrupt requests
A/D conversion interrupt requests
Software triggers
Channel priority
DMA0 > DMA1 (DMA0 takes precedence)
Transfer unit
8 bits or 16 bits
Transfer address direction
forward or fixed (The source and destination addresses cannot both be
in the forward direction.)
Transfer mode Single transfer Transfer is completed when the DMAi transfer counter (i = 0,1)
underflows after reaching the terminal count.
Repeat transfer When the DMAi transfer counter underflows, it is reloaded with the value
of the DMAi transfer counter reload register and a DMA transfer is con
tinued with it.
DMA interrupt request generation timing When the DMAi transfer counter underflowed
DMA startup
Data transfer is initiated each time a DMA request is generated when the
DMAE bit in the DMAiCON register is set to “1” (enabled).
DMA shutdown Single transfer • When the DMAE bit is set to “0” (disabled)
• After the DMAi transfer counter underflows
Repeat transfer When the DMAE bit is set to “0” (disabled)
When a data transfer is started after setting the DMAE bit to “1” (en
abled), the forward address pointer is reloaded with the value of the
SARi or the DARi pointer whichever is specified to be in the forward
direction and the DMAi transfer counter is reloaded with the value of the
DMAi transfer counter reload register.
N OTES:
1. DMA transfer is not effective to any interrupt. DMA transfer is affected neither by the I flag nor by the
interrupt control register.
2. The selectable causes of DMA requests differ with each channel.
3. Make sure that no DMAC-related registers (addresses 002016 to 003F16) are accessed by the DMAC.
Rev. 2.00 Feb.15, 2007 page 83 of 329
REJ09B0202-0200