M16C26A Datasheet, PDF (124/352 Pages) Renesas Technology Corp – 16-BIT SINGLE-CHIP MICROCOMPUTER M16C FAMILY / M16C/Tiny SERIES

M16C/26A Group (M16C/26A, M16C/26B, M16C/26T)
12. Timer
1 / fi X (2 ¹⁶ – 1)
Count source
Input signal to
“H”
TAiIN pin
“L”
PWM pulse output ^{“H”}
from TAiOUT pin
“L”
IR bit in the
“1”
TAiIC register
“0”
Trigger is not generated by this signal
1 / fj X n
fj : Frequency of count source
(f1, f2, f8, f32, fC32)
i = 0 to 4
Set to “0” upon accepting an interrupt request or by writing in program
NOTES:
1. n = 000016 to FFFE16.
2. This timing diagram is for the case where the TAi register is set to "000316", the TAiTGH and TAiTGL bits in
the ONSF or TRGSR register is set to "002" (TAiIN pin input), the MR1 bit in the TAiMR register is set to "1"
(rising edge), and the MR2 bit in the TAiMR register is set to "1" (trigger selected by TAiTGH and TAiTGL bits).
Figure 12.1.4.2. Example of 16-bit Pulse Width Modulator Operation
Count source ⁽¹⁾
1 / fj X (m + 1) X (2 ⁸ – 1)
Input signal to
“H”
TAiIN pin
“L”
Underflow signal of ^{“H”}
8-bit prescaler ⁽²⁾
“L”
PWM pulse output
“H”
from TAiOUT pin
“L”
IR bit in the
“1”
TAiIC register
“0”
1 / fj X (m + 1)
1 / fj X (m + 1) X n
fj : Frequency of count source
(f1, f2, f8, f32, fC32)
i = 0 to 4
Set to “0” upon accepting an interrupt request or by writing in program
NOTES:
1. The 8-bit prescaler counts the count source.
2. The 8-bit pulse width modulator counts the 8-bit prescaler's underflow signal.
3. m = 0016 to FF16; n = 0016 to FE16.
4. This timing diagram is for the case where the TAi register is set to "020216", the TAiTGH and TAiTGL bits in the
ONSF or TRGSR register is set to "002" (TAiIN pin input), the MR1 bit in the TAiMR register is set to "0"(falling
edge), and the MR2 bit in the TAiMR register is set to "1" (trigger selected by TAiTGH and TAiTGL bits).
Figure 12.1.4.3. Example of 8-bit Pulse Width Modulator Operation
Rev. 2.00 Feb.15, 2007 page 107 of 329
REJ09B0202-0200