English
Language : 

PIC18F2331 Datasheet, PDF (88/396 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with nanoWatt Technology, High Performance PWM and A/D
PIC18F2331/2431/4331/4431
REGISTER 7-1:
EECON1 REGISTER
R/W-x R/W-x
U-0
EEPGD CFGS
—
bit 7
R/W-0
FREE
R/W-x
WRERR
R/W-0
WREN
R/S-0
WR
R/S-0
RD
bit 0
bit 7
EEPGD: Flash Program or Data EEPROM Memory Select bit
1 = Access program Flash memory
0 = Access data EEPROM memory
bit 6
CFGS: Flash Program/Data EE or Configuration Select bit
1 = Access configuration or calibration registers
0 = Access program Flash or data EEPROM memory
bit 5
Unimplemented: Read as ‘0’
bit 4
FREE: Flash Row Erase Enable bit
1 = Erase the program memory row addressed by TBLPTR on the next WR command
(cleared by completion of erase operation)
0 = Perform write only
bit 3
WRERR: EEPROM Error Flag bit
1 = A write operation was prematurely terminated
(MCLR or WDT Reset during self-timed erase or program operation)
0 = The write operation completed normally
Note: When a WRERR occurs, the EEPGD or FREE bits are not cleared. This allows trac-
ing of the error condition.
bit 2
WREN: Erase/Write Enable bit
1 = Allows erase/write cycles
0 = Inhibits erase/write cycles
bit 1
WR: Write Control bit
1 = Initiates a data EEPROM erase/write cycle or a program memory erase cycle or write
cycle.
(The operation is self-timed and the bit is cleared by hardware once write is complete. The
WR bit can only be set (not cleared) in software.)
0 = Write cycle is completed
bit 0
RD: Read Control bit
1 = Initiates a memory read
(Read takes one cycle. RD is cleared in hardware. The RD bit can only be set (not cleared)
in software. RD bit cannot be set when EEPGD = 1.)
0 = Read completed
Legend:
R = Readable bit
W = Writable bit
x = Bit is unknown
S = Settable only
- n = Value at POR
U = Unimplemented bit, read as ‘0’
‘1’ = Bit is set
‘0’ = Bit is cleared
DS39616B-page 86
Preliminary
 2003 Microchip Technology Inc.