HD64F2636F20 Datasheet, PDF (571/1512 Pages) Renesas Technology Corp – Renesas 16-Bit Single-Chip Microcomputer H8S Family/H8S/2600 Series

H8S/2639, H8S/2638, H8S/2636,
H8S/2630, H8S/2635 Group
Section 14 Smart Card Interface
14.2.3 Serial Mode Register (SMR)
Bit
:
7
6
5
4
3
2
1
0
GM
BLK
PE
O/E BCP1 BCP0 CKS1 CKS0
Initial value :
0
0
0
0
0
0
0
0
R/W
: R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Note: When the smart card interface is used, be sure to make the 1 setting shown for bit 5.
The function of bits 7, 6, 3, and 2 of SMR changes in Smart Card interface mode.
Bit 7—GSM Mode (GM): Sets the smart card interface function to GSM mode.
This bit is cleared to 0 when the normal smart card interface is used. In GSM mode, this bit is set
to 1, the timing of setting of the TEND flag that indicates transmission completion is advanced
and clock output control mode addition is performed. The contents of the clock output control
mode addition are specified by bits 1 and 0 of the serial control register (SCR).
Bit 7
GM
Description
0
Normal smart card interface mode operation
(Initial value)
• TEND flag generation 12.5 etu (11.5 etu in block transfer mode) after beginning of
start bit
• Clock output ON/OFF control only
1
GSM mode smart card interface mode operation
• TEND flag generation 11.0 etu after beginning of start bit
• High/Low fixing control possible in addition to clock output ON/OFF control (set by
SCR)
Note: etu: Elementary time unit (time for transfer of 1 bit)
REJ09B0103-0800 Rev. 8.00
May 28, 2010
Page 521 of 1458