MEGA128CAN Datasheet, PDF (201/413 Pages) ATMEL Corporation – Microcontroller WITH 128K BYTES OF ISP FLASH AND CAN CONTROLLER

Address Packet Format
Data Packet Format
AT90CAN128
All address packets transmitted on the TWI bus are 9 bits long, consisting of 7 address
bits, one READ/WRITE control bit and an acknowledge bit. If the READ/WRITE bit is
set, a read operation is to be performed, otherwise a write operation should be per-
formed. When a slave recognizes that it is being addressed, it should acknowledge by
pulling SDA low in the ninth SCL (ACK) cycle. If the addressed slave is busy, or for
some other reason can not service the master’s request, the SDA line should be left
high in the ACK clock cycle. The master can then transmit a STOP condition, or a
REPEATED START condition to initiate a new transmission. An address packet consist-
ing of a slave address and a READ or a WRITE bit is called SLA+R or SLA+W,
respectively.
The MSB of the address byte is transmitted first. Slave addresses can freely be allo-
cated by the designer, but the address 0000 000 is reserved for a general call.
When a general call is issued, all slaves should respond by pulling the SDA line low in
the ACK cycle. A general call is used when a master wishes to transmit the same mes-
sage to several slaves in the system. When the general call address followed by a Write
bit is transmitted on the bus, all slaves set up to acknowledge the general call will pull
the SDA line low in the ack cycle. The following data packets will then be received by all
the slaves that acknowledged the general call. Note that transmitting the general call
address followed by a Read bit is meaningless, as this would cause contention if several
slaves started transmitting different data.
All addresses of the format 1111 xxx should be reserved for future purposes.
Figure 93. Address Packet Format
Addr MSB
Addr LSB R/W
ACK
SDA
SCL
START
1
2
7
8
9
All data packets transmitted on the TWI bus are 9 bits long, consisting of one data byte
and an acknowledge bit. During a data transfer, the master generates the clock and the
START and STOP conditions, while the receiver is responsible for acknowledging the
reception. An Acknowledge (ACK) is signalled by the receiver pulling the SDA line low
during the ninth SCL cycle. If the receiver leaves the SDA line high, a NACK is signalled.
When the receiver has received the last byte, or for some reason cannot receive any
more bytes, it should inform the transmitter by sending a NACK after the final byte. The
MSB of the data byte is transmitted first.
4250E–CAN–12/04
201