PIC18F6525_13 Datasheet, PDF (332/400 Pages) Microchip Technology – 64/80-Pin High-Performance, 64-Kbyte Enhanced Flash Microcontrollers with A/D

PIC18F6525/6621/8525/8621
27.3 DC Characteristics: PIC18F6525/6621/8525/8621 (Industrial, Extended)
PIC18LF6X2X/8X2X (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA  +85°C for industrial
-40°C TA  +125°C for extended
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VOL Output Low Voltage
D080
I/O ports
—
0.6
V IOL = 8.5 mA, VDD = 4.5V,
-40C to +85C
D080A
—
0.6
V IOL = 7.0 mA, VDD = 4.5V,
-40C to +125C
D083
OSC2/CLKO
(RC mode)
—
0.6
V IOL = 1.6 mA, VDD = 4.5V,
-40C to +85C
D083A
VOH
Output High Voltage⁽³⁾
—
0.6
V IOL = 1.2 mA, VDD = 4.5V,
-40C to +125C
D090
I/O ports
VDD – 0.7
—
V IOH = -3.0 mA, VDD = 4.5V,
-40C to +85C
D090A
VDD – 0.7
—
V IOH = -2.5 mA, VDD = 4.5V,
-40C to +125C
D092
OSC2/CLKO
(RC mode)
VDD – 0.7
—
V IOH = -1.3 mA, VDD = 4.5V,
-40C to +85C
D092A
VDD – 0.7
—
V IOH = -1.0 mA, VDD = 4.5V,
-40C to +125C
D150 VOD Open-Drain High Voltage
—
8.5
V RA4 pin
Capacitive Loading Specs
on Output Pins
D100^{(4) COSC2 OSC2 pin}
—
15
pF In XT, HS and LP modes
when external clock is used
to drive OSC1
D101 CIO
D102 CB
All I/O pins and OSC2
(in RC mode)
SCL, SDA
—
50
pF To meet the AC Timing
Specifications
—
400
pF In I²C™ mode
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC^® device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
DS39612C-page 332
 2003-2013 Microchip Technology Inc.