HD6433937 Datasheet, PDF (486/521 Pages) Hitachi Semiconductor – Hardware Manual

IRR2—Interrupt request register 2
H'F7
System control
Bit
7
6
5
4
3
2
1
0
IRRDT IRRAD — IRRTG IRRTFH IRRTFL IRRTC —
Initial value
0
0
0
0
0
0
0
0
Read/Write R/(W)* R/(W)* R/W R/(W)* R/(W)* R/(W)* R/(W)* —
Timer C interrupt request flag
0 Clearing conditions:
When IRRTC = 1, it is cleared by writing 0
1 Setting conditions:
When the timer C counter value overflows
(from H'FF to H'00) or underflows (from H'00 to H'FF)
Timer FL interrupt request flag
0 Clearing conditions:
When IRRTFL = 1, it is cleared by writing 0
1 Setting conditions:
When counter FL and output compare register FL
match in 8-bit timer mode
Timer FH interrupt request flag
0 Clearing conditions:
When IRRTFH = 1, it is cleared by writing 0
1 Setting conditions:
When counter FH and output compare register FH match
in 8-bit timer mode, or when 16-bit counters FL and FH
and output compare registers FL and FH match in 16-bit timer mode
Timer G interrupt request flag
0 Clearing conditions:
When IRRTG = 1, it is cleared by writing 0
1 Setting conditions:
When the TMIG pin is designated for TMIG input and
the designated signal edge is input
A/D converter interrupt request flag
0 Clearing conditions:
When IRRAD = 1, it is cleared by writing 0
1 Setting conditions:
When the A/D converter completes conversion and
ADSF is reset
Direct transition interrupt request flag
0 Clearing conditions:
When IRRDT = 1, it is cleared by writing 0
1 Setting conditions:
When a SLEEP instruction is executed while DTON is
set to 1, and a direct transition is made
Note: * Bits 7, 6 and 4 to 1 can only be written with 0, for flag clearing.
474