80KSBR200 Datasheet, PDF (79/172 Pages) Integrated Device Technology – sRIO SERIAL BUFFER FLOW-CONTROL DEVICE

IDT 80KSBR200
Notes
Advanced Datasheet*
Bit
Field Name
Reset
Value
Comment
4
RTRY_TRES_EXC 1b0
21:5
-
0
Retry Error Threshold Exceeded:
The allowed number of logical retries has been exceeded.
Reserved.
22
UNSUP_TRANS
1b0
Unsupported Transaction:
A transaction is received that is not supported in the Destination
Operation CAR (IO/MSG/GSM logical).
23
UNSOL_RES
1b0
Unsolicited Response:
An unsolicited/unexpected Response packet was received (IO/MSG/
GSM logical).
24
PKT_RES_TOUT 1b0
Packet Response Time-out:
A required response has not been received within the specified time-
out interval (IO/MSG/GSM logical).
25
MSG_REQ_TOUT 1b0
26
ILL_TRANS_ERR 1b0
27
ILL_TRANS_DEC 1b0
28
MSG_FMT_ERR 1b0
29
GSM_ERR_RES 1b0
Message Request Time-out:
A required message request has not been received within the speci-
fied time-out interval (MSG logical).
Illegal Transaction Target Error:
Received a packet that contained a destination ID that is not defined
for this end point.
Illegal Transaction Decode:
Received illegal fields in the request/response packet for a sup-
ported transaction (IO/MSG/GSM logical).
Message Format Error:
Received MESSAGE packet data payload with an invalid size or
segment (MSG logical).
GSM Error Response:
Received a response of ‘ERROR’ for a GSM Logical Layer Request.
30
MSG_ERR_RES 1b0
Message Error Response:
Received a response of ‘ERROR’ for an MSG Logical Layer
Request.
31
IO_ERR_RES
1b0
IO Error Response:
Received a response of ‘ERROR’ for an IO Logical Layer Request.
Note:
1.
Table 36 Logical/Transport Layer Error Detect CSR
The above register is described in the RIO Specification Part 8, sec. 2.3.2.2
Logical/Transport Layer Error Enable CSR
This register contains the bits that control if an error condition locks the Logical/Transport Layer Error Detect and
Capture registers and is reported to the system host. LTLEECSR is stored in all ports and the Message Unit
Name: LTL_ERR_EN_CSR
Address: 0x00060C
Bit
Field Name
2:0
-
3
TRAN_SZE_EN
Reset
Value
Comment
0
Reserved.
1b0
Transport Size Error Enable:
Enable error reporting when the tt field is nor consistent with bit 27 of
the Processing Element Features CAR (i.e., the tt value is reserved
or indicates a common transport system that is unsupported by this
device).
Table 37 Logical/Transport Layer Error Enable CSR
79 of 172
March 19, 2007
„2005 Integrated Device Technology, Inc. All rights reserved. Advanced Datasheet for informational purposes only. Product specifications subject to change without notice.NOT AN OFFER FOR SALE The information presented herein is subject to a
Non-Disclosure Agreement (NDA) and is for planning purposes only. Nothing contained in this presentation, whether verbal or written, is intended as, or shall have the effect of, a sale or an offer for sale that creates a contractual power of acceptance.