80KSBR200 Datasheet, PDF (130/172 Pages) Integrated Device Technology – sRIO SERIAL BUFFER FLOW-CONTROL DEVICE

IDT 80KSBR200
Notes
Advanced Datasheet*
13.6.1 Receiver Eye Diagrams
For each baud rate at which an LP-Serial receiver is specified to operate, the receiver meets the corresponding Bit
Error Rate specification (Receiver AC Timing Specification - 1.25 GBaud, Receiver AC Timing Specification - 2.5 GBaud,
and Receiver AC Timing Specification - 3.125 GBaud) when the eye pattern of the receiver test signal (exclusive of sinuso-
idal jitter) falls entirely within the un-shaded portion of the Receiver Input Compliance Mask shown in Figure 36 with the
parameters specified in Figure 37. The eye pattern of the receiver test signal is measured at the input pins of the receiving
device with the device replaced with a 100 Ohm +/- 5% differential resistive load.
Figure 37 Receiver Input Compliance Mask
Figure 38 Receiver Input Compliance Mask Parameters exclusive of Sinusoidal Jitter
130 of 172
March 19, 2007
„2005 Integrated Device Technology, Inc. All rights reserved. Advanced Datasheet for informational purposes only. Product specifications subject to change without notice.NOT AN OFFER FOR SALE The information presented herein is subject to a
Non-Disclosure Agreement (NDA) and is for planning purposes only. Nothing contained in this presentation, whether verbal or written, is intended as, or shall have the effect of, a sale or an offer for sale that creates a contractual power of acceptance.