MB86296 Datasheet, PDF (326/352 Pages) Fujitsu Component Limited. – PCI Graphics Controller Specification

FUJITSU LIMITED PRELIMINARY AND CONFIDENTIAL
15. ELECTRICAL CHARACTERISTICS
15.1 Introduction
The values in this chapter are valid for the final specification of MB86296.
15.2 Maximum Rating
Maximum Rating
Parameter
Symbol
Maximum rating
Unit
Power supply voltage
VDDL ^*1
VDDH
-0.5 < VDDL < 2.5
-0.5 < VDDH < 4.0
V
Input voltage
VI
-0.5 < VI < VDDH+0.5 (<4.0)
V
Output current
IO
±13
mA
Ambient for storage
temperature
TST
-55 < TST < +125
°C
*1 Includes PLL power supply
<Notes>
Semiconductor devices can be permanently damaged by application of stress (voltage, current,
temperature, etc) in excess of absolute maximum ratings. Do not exceed these ratings.
Do not directly connect output pins or bidirectional pins of IC products to each other or VDD or
VSS to avoid the breakdown of the device. However direct connection of the output pins or
bidirectional pins to each other is possible, if the output pins are designed to avoid a conflict in a
timing.
Because semiconductor devices are particularly susceptible to damaged by static electricity, you
must take the measure like ground all fixtures and instruments.
In CMOS ICs, a latch-up phenomenon is caused when an voltage exceeding Vcc or an voltage
below Vss is applied to input or output pins or a voltage exceeding the rating is applied across
Vcc and Vss. When a latch-up is caused, the power supply current may be dramatically increased
causing resultant thermal break-down of devices. To avoid the latch-up, make sure that the
voltage does not exceed the maximum rating.
MB86296S<Coral-PA>
316
Specification Manual Rev0.1