MB86296 Datasheet, PDF (247/352 Pages) Fujitsu Component Limited. – PCI Graphics Controller Specification

FUJITSU LIMITED PRELIMINARY AND CONFIDENTIAL
L2BLD (L2 Blend)
Register
address
DisplayBaseAddress + 18CH
Bit number 31 30 29 28 ----- 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit field name
Reserved
L2BE L2BS L2BI L2BP Reserved
L2BR
R/W
Initial value
This register specifies the blend parameters for the L2 layer.
Bit 7 to 0 L2BR (L2 layer Blend Ratio)
Sets the blend ratio. Basically, the blend ratio is setting value/256.
Bit 13 L2BP (L2 layer Blend Plane)
Specifies that the L5 layer is the blend plane.
0 Value of L2BR used as blend ratio
1 Pixel of L5 layer used as blend ratio
Bit 14 L2BI (L2 layer Blend Increment)
Selects whether or not 1/256 is added when the blend ratio is not “0”.
0 Blend ratio calculated as is
1 1/256 added when blend ratio≠ 0
Bit 15 L2BS (L2 layer Blend Select)
Selects the blend calculation expression.
0 Upper image × Blend ratio + Lower image × (1 – Blend ratio)
1 Upper image × (1 – Blend ratio) + Lower image × Blend ratio
Bit 16 L2BE (L2 layer Blend Enable)
This bit enables blending.
0 Overlay via transparent color
1 Overlay via blending
Before blending, the blend mode must be specified using L2BE, and alpha must also be enabled
for L2 layer display data. For direct color, alpha is specified using the MSB of data; for indirect
color, alpha is specified using the MSB of palette data.
MB86296S <Coral-PA>
237
Specification Manual Rev0.1