MC68HC08BD24 Datasheet, PDF (163/244 Pages) Motorola, Inc – HCMOS Microcontroller Unit

SRW — DDC Slave Read/Write
This bit indicates the data direction when the module is in slave mode.
It is updated after the calling address is received from a master
device. SRW = 1 when the calling master is reading data from the
module (slave transmit mode). SRW = 0 when the master is writing
data to the module (receive mode).
1 = Slave mode transmit
0 = Slave mode receive
RXAK — DDC Receive Acknowledge
When this bit is cleared, it indicates an acknowledge signal has been
received after the completion of 8 data bits transmission on the bus.
When RXAK is set, it indicates no acknowledge signal has been
detected at the 9th clock; the module will release the SDA line for the
master to generate "stop" or "repeated start" condition. Reset sets this
bit.
1 = No acknowledge signal received at 9th clock bit
0 = Acknowledge signal received at 9th clock bit
SCLIF — SCL Interrupt Flag
This flag is set when a falling edge is detected on the SCL line, only if
DDC1EN bit is set. SCLIF generates an interrupt request to CPU if the
SCLIEN bit in DCR is also set. SCLIF is cleared by writing "0" to it or
when the DCC1EN = 0, or DEN = 0. Reset clears this bit.
1 = Falling edge detected on SCL line
0 = No falling edge detected on SCL line
TXBE — DDC Transmit Buffer Empty
This flag indicates the status of the data transmit register (DDTR).
When the CPU writes the data to the DDTR, the TXBE flag will be
cleared. TXBE is set when DDTR is emptied by a transfer of its data
to the output circuit. Reset sets this bit.
1 = Data transmit register empty
0 = Data transmit register full
MC68HC08BD24 — Rev. 1.1
Freescale Semiconductor
Technical Data
163