C8051F52X_12 Datasheet, PDF (214/221 Pages) Silicon Laboratories – 8/4/2 kB ISP Flash MCU Family

C8051F52x/F53x
21. C2 Interface
C8051F52x/F52xA/F53x/F53xA devices include an on-chip Silicon Laboratories 2-Wire (C2) debug inter-
face to allow Flash programming and in-system debugging with the production part installed in the end
application. The C2 interface uses a clock signal (C2CK) and a bi-directional C2 data signal (C2D) to trans-
fer information between the device and a host system. See the C2 Interface Specification for details on the
C2 protocol.
21.1. C2 Interface Registers
The following describes the C2 registers necessary to perform Flash programming functions through the
C2 interface. All C2 registers are accessed through the C2 interface as described in the C2 Interface Spec-
ification.
C2 Register Definition 21.1. C2ADD: C2 Address
Reset Value
00000000
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
Bits7–0: The C2ADD register is accessed via the C2 interface to select the target Data register for
C2 Data Read and Data Write commands.
Address
0x00
0x01
0x02
0xB4
Description
Selects the Device ID register for Data Read instructions (DEVICEID)
Selects the Revision ID register for Data Read instructions (REVID)
Selects the C2 Flash Programming Control register for Data Read/Write instructions
(FPCTL)
Selects the C2 Flash Programming Data register for Data Read/Write instructions
(FPDAT)
C2 Register Definition 21.2. DEVICEID: C2 Device ID
Reset Value
00010001
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
This read-only register returns the 8-bit device ID: 0x11 (C8051F52x/F52xA/F53x/F53xA).
214
Rev. 1.4