C8051F52X_12 Datasheet, PDF (129/221 Pages) Silicon Laboratories – 8/4/2 kB ISP Flash MCU Family

C8051F52x/F53x
In addition to performing general purpose I/O, P0 and P1 can generate a port match event if the logic lev-
els of the Port’s input pins match a software controlled value. A port match event is generated if
(P0 & P0MASK) does not equal (P0MATCH & P0MASK) or if (P1 & P1MASK) does not equal
(P1MATCH & P1MASK). This allows Software to be notified if a certain change or pattern occurs on P0 or
P1 input pins regardless of the XBRn settings. A port match event can cause an interrupt if EMAT (EIE2.1)
is set to 1 or cause the internal oscillator to awaken from SUSPEND mode. See Section “14.1.1. Internal
Oscillator Suspend Mode” on page 136 for more information.
SFR Definition 13.3. P0: Port0
R/W
P0.7
Bit7
R/W
P0.6
Bit6
R/W
P0.5
Bit5
R/W
P0.4
Bit4
R/W
P0.3
Bit3
R/W
P0.2
Bit2
R/W
P0.1
Bit1
R/W
Reset Value
P0.0 11111111
Bit0
Bit
Addressable
SFR Address: 0x80
Bits7–0: P0.[7:0]
Write - Output appears on I/O pins per Crossbar Registers.
0: Logic Low Output.
1: Logic High Output (high impedance if corresponding P0MDOUT.n bit = 0).
Read - Always reads 0 if selected as analog input in register P0MDIN. Directly reads Port
pin when configured as digital input.
0: P0.n pin is logic low.
1: P0.n pin is logic high.
SFR Definition 13.4. P0MDIN: Port0 Input Mode
R/W
R/W
R/W
R/W
R/W
R/W
R/W
R/W
Reset Value
11111111
Bit7
Bit6
Bit5
Bit4
Bit3
Bit2
Bit1
Bit0
SFR Address: 0xF1
Bits7–0: Analog Input Configuration Bits for P0.7–P0.0 (respectively).
Port pins configured as analog inputs have their weak pullup, digital driver, and digital
receiver disabled.
0: Corresponding P0.n pin is configured as an analog input.
1: Corresponding P0.n pin is not configured as an analog input.
Rev. 1.4
129