PIC18F44J50-I Datasheet, PDF (264/562 Pages) Microchip Technology – 28/44-Pin, Low-Power, High-Performance USB Microcontrollers

PIC18F46J50 FAMILY
REGISTER 18-3: ECCPxDEL: ENHANCED PWM CONTROL REGISTER (ACCESS FBDh, FB7h)
R/W-0
PxRSEN
bit 7
R/W-0
PxDC6
R/W-0
PxDC5
R/W-0
PxDC4
R/W-0
PxDC3
R/W-0
PxDC2
R/W-0
PxDC1
R/W-0
PxDC0
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7
bit 6-0
PxRSEN: PWM Restart Enable bit
1 = Upon auto-shutdown, the ECCPxASE bit clears automatically once the shutdown event goes
away; the PWM restarts automatically
0 = Upon auto-shutdown, ECCPxASE must be cleared by software to restart the PWM
PxDC<6:0>: PWM Delay Count bits
PxDCn = Number of FOSC/4 (4 * TOSC) cycles between the scheduled time when a PWM signal
should transition active and the actual time it transitions active.
18.5.7 PULSE STEERING MODE
In Single Output mode, pulse steering allows any of the
PWM pins to be the modulated signal. Additionally, the
same PWM signal can simultaneously be available on
multiple pins.
Once the Single Output mode is selected
(CCPxM<3:2> = 11 and PxM<1:0> = 00 of the
CCPxCON register), the user firmware can bring out
the same PWM signal to one, two, three or four output
pins by setting the appropriate STR<D:A> bits of the
PSTRxCON register, as provided in Table 18-4.
Note:
The associated TRIS bits must be set to
output (‘0’) to enable the pin output driver
in order to see the PWM signal on the pin.
While the PWM Steering mode is active, the
CCPxM<1:0> bits of the CCPxCON register select the
PWM output polarity for the Px<D:A> pins.
The PWM auto-shutdown operation also applies to
PWM Steering mode, as described in Section 18.5.4
“Enhanced PWM Auto-Shutdown Mode”. An
auto-shutdown event will only affect pins that have
PWM outputs enabled.
DS39931D-page 264
 2011 Microchip Technology Inc.