English
Language : 

PIC18F44J50-I Datasheet, PDF (105/562 Pages) Microchip Technology – 28/44-Pin, Low-Power, High-Performance USB Microcontrollers
PIC18F46J50 FAMILY
REGISTER 7-1: EECON1: EEPROM CONTROL REGISTER 1 (ACCESS FA6h)
U-0
—
bit 7
U-0
R/W-0
R/W-0
R/W-x
R/W-0
R/S-0
—
WPROG
FREE
WRERR
WREN
WR
U-0
—
bit 0
Legend:
R = Readable bit
-n = Value at POR
S = Settable bit (cannot be cleared in software)
W = Writable bit
U = Unimplemented bit, read as ‘0’
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 7-6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
Unimplemented: Read as ‘0’
WPROG: One Word-Wide Program bit
1 = Program 2 bytes on the next WR command
0 = Program 64 bytes on the next WR command
FREE: Flash Erase Enable bit
1 = Perform an erase operation on the next WR command (cleared by hardware after completion of erase)
0 = Perform write only
WRERR: Flash Program Error Flag bit
1 = A write operation is prematurely terminated (any Reset during self-timed programming in normal
operation or an improper write attempt)
0 = The write operation is complete
WREN: Flash Program Write Enable bit
1 = Allows write cycles to Flash program memory
0 = Inhibits write cycles to Flash program memory
WR: Write Control bit
1 = Initiates a program memory erase cycle or write cycle
(The operation is self-timed and the bit is cleared by hardware once the write is complete. The WR
bit can only be set (not cleared) in software.)
0 = Write cycle is complete
Unimplemented: Read as ‘0’
 2011 Microchip Technology Inc.
DS39931D-page 105