MC68HC08XL36 Datasheet, PDF (96/362 Pages) Freescale Semiconductor, Inc – HCMOS Microcontroller Unit

CGM
Freescale Semiconductor, Inc.
BCS — Base Clock Select Bit
This read/write bit selects either the crystal oscillator output,
CGMXCLK, or the VCO clock, CGMVCLK, as the source of the CGM
output, CGMOUT. CGMOUT frequency is one-half the frequency of
the selected clock. BCS cannot be set while the PLLON bit is clear.
After toggling BCS, it may take up to three CGMXCLK and three
CGMVCLK cycles to complete the transition from one source clock to
the other. During the transition, CGMOUT is held in stasis. (See Base
Clock Selector Circuit on page 91.) Reset and the STOP instruction
clear the BCS bit.
1 = CGMVCLK divided by two drives CGMOUT
0 = CGMXCLK divided by two drives CGMOUT
NOTE:
PLLON and BCS have built-in protection that prevents the base clock
selector circuit from selecting the VCO clock as the source of the base
clock if the PLL is off. Therefore, PLLON cannot be cleared when BCS
is set, and BCS cannot be set when PLLON is clear. If the PLL is off
(PLLON = 0), selecting CGMVCLK requires two writes to the PLL control
register. (See Base Clock Selector Circuit on page 91.)
Bits 3–0 — Unimplemented
These bits provide no function and always read as logic 1s.
PLL Bandwidth
Control Register
The PLL bandwidth control register does the following:
• Selects automatic or manual (software-controlled) bandwidth
control mode
• Indicates when the PLL is locked
• In automatic bandwidth control mode, indicates when the PLL is in
acquisition or tracking mode
• In manual operation, forces the PLL into acquisition or tracking
mode
MC68HC08XL36
96
Clock Generator Module (CGM)
For More Information On This Product,
Go to: www.freescale.com
16-cgm1m_a
MOTOROLA