MC68HC08XL36 Datasheet, PDF (221/362 Pages) Freescale Semiconductor, Inc – HCMOS Microcontroller Unit

Freescale Semiconductor, Inc.
Serial Peripheral Interface Module (SPI)
I/O Registers
SPWOM — SPI Wired-OR Mode Bit
This read/write bit disables the pullup devices on pins SPSCK, MOSI,
and MISO so that those pins become open-drain outputs.
1 = Wired-OR SPSCK, MOSI, and MISO pins
0 = Normal push-pull SPSCK, MOSI, and MISO pins
SPE — SPI Enable
This read/write bit enables the SPI module. Clearing SPE causes a
partial reset of the SPI. (See Resetting the SPI on page 213.) Reset
clears the SPE bit.
1 = SPI module enabled
0 = SPI module disabled
SPTIE— SPI Transmit Interrupt Enable
This read/write bit enables CPU interrupt requests or DMA service
requests generated by the SPTE bit. SPTE is set when a byte
transfers from the transmit data register to the shift register. Reset
clears the SPTIE bit.
1 = SPTE CPU interrupt requests or SPTE DMA service requests
enabled
0 = SPTE CPU interrupt requests or SPTE DMA service requests
disabled
SPI Status and
Control Register
The SPI status and control register contains flags to signal the following
conditions:
• Receive data register full
• Failure to clear SPRF bit before next byte is received (overflow
error)
• Inconsistent logic level on SS pin (mode fault error)
• Transmit data register empty
31-spi_c
MOTOROLA
Serial Peripheral Interface Module (SPI)
For More Information On This Product,
Go to: www.freescale.com
MC68HC08XL36
221