ATMEGA8U2_14 Datasheet, PDF(239/310 Page) ATMEL Corporation – 125 Powerful Instructions – Most Single Clock Cycle Execution

English

English German Russian Spanish Italian Polish Chinese Japanese Korean French Portuguese	Language :

ATMEGA8U2_14 Datasheet, PDF (239/310 Pages) ATMEL Corporation – 125 Powerful Instructions – Most Single Clock Cycle Execution

◁

ATmega8U2/16U2/32U2

23.8.14 ATmega8U2 Boot Loader Parameters

In Table 23-8 through Table 23-10, the parameters used in the description of the Self-Programming are given.

Table 23-8. Boot Size Configuration(1)(Word Addresses)

1 1 256 words

1 0 512 words

0 1 1024 words

0 0 2048 words

4

0x0000 - 0xEFF

8

0x0000 - 0xDFF

16

0x0000 - 0xBFF

32

0x0000 - 0x7FF

0xF00 - 0xFFF

0xE00 - 0xFFF

0xC00 - 0xFFF

0x800 - 0xFFF

0xEFF

0xDFF

0xBFF

0x7FF

0xF00

0xE00

0xC00

0x800

(Page size = 64 words = 128 bytes)

Note: 1. The different BOOTSZ Fuse configurations are shown in Figure 23-2.

Table 23-9. Read-While-Write Limit(1)

Section

Pages

Address

Read-While-Write section (RWW)

32

0x0000 - 0x07FF

No Read-While-Write section (NRWW)

32

0x0800 - 0x0FFF

Note: 1. For details about these two section, see âNRWW â No Read-While-Write Sectionâ on page 227 and âRWW â Read-While-

Write Sectionâ on page 227.

Table 23-10. Explanation of different variables used in Figure 23-4 and the mapping to the Z-pointer

Variable

Corresponding

Z-value

Description(1)

PCMSB

12

Most significant bit in the Program Counter. (The Program

Counter is 13 bits PC[12:0])

PAGEMSB

5

Most significant bit which is used to address the words within

one page (64 words in a page requires six bits PC [5:0]).

ZPCMSB

Z13

Bit in Z-pointer that is mapped to PCMSB. Because Z0 is not

used, the ZPCMSB equals PCMSB + 1.

ZPAGEMSB

Z6

Bit in Z-pointer that is mapped to PCMSB. Because Z0 is not

used, the ZPAGEMSB equals PAGEMSB + 1.

PCPAGE

PC[12:6]

Z13:Z7

Program Counter page address: Page select, for Page Erase

and Page Write

PCWORD

PC[5:0]

Z6:Z1

Program Counter word address: Word select, for filling

temporary buffer (must be zero during Page Write operation)

Note: 1. Z0: should be zero for all SPM commands, byte select for the (E)LPM instruction.

See âAddressing the Flash During Self-Programmingâ on page 232 for details about the use of Z-pointer during Self-

Programming.

7799DâAVRâ11/10

239

▷