MC908AZ60ACFUER Datasheet, PDF (322/414 Pages) Freescale Semiconductor, Inc – To provide the most up-to-date information, the revision of our documents on the World Wide Web will be the most current. Your printed copy may be an earlier revision. To verify you have the latest information available, refer to:

Timer Interface Module A (TIMA)
When ELSxB:A = 00, this read/write bit selects the initial output level of the TACHx pin once PWM,
output compare mode or input capture mode is enabled. See Table 25-2. Reset clears the MSxA bit.
1 = Initial output level low
0 = Initial output level high
NOTE
Before changing a channel function by writing to the MSxB or MSxA bit, set
the TSTOP and TRST bits in the TIMA status and control register (TASC).
ELSxB and ELSxA — Edge/Level Select Bits
When channel x is an input capture channel, these read/write bits control the active edge-sensing logic
on channel x.
When channel x is an output compare channel, ELSxB and ELSxA control the channel x output
behavior when an output compare occurs.
When ELSxB and ELSxA are both clear, channel x is not connected to port E or port F and pin
PTEx/TACHx or pin PTFx/TACHx is available as a general-purpose I/O pin. However, channel x is at
a state determined by these bits and becomes transparent to the respective pin when PWM, input
capture mode or output compare operation mode is enabled. Table 25-2 shows how ELSxB and
ELSxA work. Reset clears the ELSxB and ELSxA bits.
MSxB
X
X
0
0
0
0
0
0
0
1
1
1
MSxA
0
1
0
0
0
1
1
1
1
X
X
X
Table 25-2. Mode, Edge, and Level Selection
ELSxB
0
0
0
1
1
0
0
1
1
0
1
1
ELSxA
0
0
1
0
1
0
1
0
1
1
0
1
Mode
Output preset
Input capture
Output compare
or PWM
Buffered output
compare or
buffered PWM
Configuration
Pin under port control; initial output level high
Pin under port control; initial output level low
Capture on rising edge only
Capture on falling edge only
Capture on rising or falling edge
Software compare only
Toggle output on compare
Clear output on compare
Set output on compare
Toggle output on compare
Clear output on compare
Set output on compare
NOTE
Before enabling a TIMA channel register for input capture operation, make
sure that the PTEx/TACHx pin or PTFx/TACHx pin is stable for at least two
bus clocks.
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
322
Freescale Semiconductor