MC908AZ60ACFUER Datasheet, PDF (276/414 Pages) Freescale Semiconductor, Inc – To provide the most up-to-date information, the revision of our documents on the World Wide Web will be the most current. Your printed copy may be an earlier revision. To verify you have the latest information available, refer to:

MSCAN Controller (MSCAN08)
.
Table 23-2. MSCAN08 versus CPU Operating Modes
MSCAN Mode
Power Down
Sleep
Soft Reset
Normal
1. ‘X’ means don’t care.
CPU Mode
STOP
SLPAK = X⁽¹⁾
SFTRES = X
WAIT or RUN
SLPAK = 1
SFTRES = 0
SLPAK = 0
SFTRES = 1
SLPAK = 0
SFTRES = 0
23.8.1 MSCAN08 Sleep Mode
The CPU can request the MSCAN08 to enter the low-power mode by asserting the SLPRQ bit in the
module configuration register (see Figure 23-6). The time when the MSCAN08 enters Sleep mode
depends on its activity:
• if it is transmitting, it continues to transmit until there is no more message to be transmitted, and
then goes into Sleep mode
• if it is receiving, it waits for the end of this message and then goes into Sleep mode
• if it is neither transmitting or receiving, it will immediately go into Sleep mode
NOTE
The application software must avoid setting up a transmission (by clearing
or more TXE flags) and immediately request Sleep mode (by setting
SLPRQ). It then depends on the exact sequence of operations whether
MSCAN08 starts transmitting or goes into Sleep mode directly.
MCU
or MSCAN08
MSCAN08 Running
SLPRQ = 0
SLPAK = 0
MCU
MSCAN08 Sleeping
SLPRQ = 1
SLPAK = 1
Sleep Request
SLPRQ = 1
SLPAK = 0
MSCAN08
Figure 23-6. Sleep Request/Acknowledge Cycle
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
276
Freescale Semiconductor