MC908AZ60ACFUER Datasheet, PDF (239/414 Pages) Freescale Semiconductor, Inc – To provide the most up-to-date information, the revision of our documents on the World Wide Web will be the most current. Your printed copy may be an earlier revision. To verify you have the latest information available, refer to:

I/O Registers
Register Name and Address
Bit 7
6
Read: CH0F
Write: 0
CH0IE
Reset: 0
0
TBSC0 — $0045
5
4
MS0B MS0A
0
0
3
ELS0B
0
2
ELS0A
0
1
TOV0
0
Bit 0
CH0MAX
0
Register Name and Address
TBSC1 — $0048
Bit 7
6
5
4
3
2
1
Bit 0
Read: CH1F
0
CH1IE
MS1A ELS1B ELS1A TOV1 CH1MAX
Write: 0
R
Reset: 0
0
0
0
0
0
0
0
R = Reserved
Figure 20-7. TIMB Channel Status and Control Registers (TBSC0–TBSC1)
CHxF — Channel x Flag Bit
When channel x is an input capture channel, this read/write bit is set when an active edge occurs on
the channel x pin. When channel x is an output compare channel, CHxF is set when the value in the
TIMB counter registers matches the value in the TIMB channel x registers.
When CHxIE = 1, clear CHxF by reading TIMB channel x status and control register with CHxF set,
and then writing a logic 0 to CHxF. If another interrupt request occurs before the clearing sequence is
complete, then writing logic 0 to CHxF has no effect. Therefore, an interrupt request cannot be lost due
to inadvertent clearing of CHxF.
Reset clears the CHxF bit. Writing a logic 1 to CHxF has no effect.
1 = Input capture or output compare on channel x
0 = No input capture or output compare on channel x
CHxIE — Channel x Interrupt Enable Bit
This read/write bit enables TIMB CPU interrupts on channel x.
Reset clears the CHxIE bit.
1 = Channel x CPU interrupt requests enabled
0 = Channel x CPU interrupt requests disabled
MSxB — Mode Select Bit B
This read/write bit selects buffered output compare/PWM operation. MSxB exists only in the TIMB
channel 0.
Setting MS0B disables the channel 1 status and control register and reverts TBCH1 to
general-purpose I/O.
Reset clears the MSxB bit.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MSxA — Mode Select Bit A
When ELSxB:A ≠ 00, this read/write bit selects either input capture operation or unbuffered output
compare/PWM operation (see Table 20-2).
1 = Unbuffered output compare/PWM operation
0 = Input capture operation
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
Freescale Semiconductor
239