MC908AZ60ACFUER Datasheet, PDF (236/414 Pages) Freescale Semiconductor, Inc – To provide the most up-to-date information, the revision of our documents on the World Wide Web will be the most current. Your printed copy may be an earlier revision. To verify you have the latest information available, refer to:

Timer Interface Module B (TIMB)
Address: $0040
Bit 7
6
5
4
3
2
1
Bit 0
Read: TOF
0
0
TOIE TSTOP
Write: 0
TRST
R
PS2
PS1
PS0
Reset: 0
0
1
0
0
0
0
0
R
= Reserved
Figure 20-4. TIMB Status and Control Register (TBSC)
TOF — TIMB Overflow Flag Bit
This read/write flag is set when the TIMB counter reaches the modulo value programmed in the TIMB
counter modulo registers. Clear TOF by reading the TIMB status and control register when TOF is set
and then writing a logic 0 to TOF. If another TIMB overflow occurs before the clearing sequence is
complete, then writing logic 0 to TOF has no effect. Therefore, a TOF interrupt request cannot be lost
due to inadvertent clearing of TOF. Reset clears the TOF bit. Writing a logic 1 to TOF has no effect.
1 = TIMB counter has reached modulo value
0 = TIMB counter has not reached modulo value
TOIE — TIMB Overflow Interrupt Enable Bit
This read/write bit enables TIMB overflow interrupts when the TOF bit becomes set. Reset clears the
TOIE bit.
1 = TIMB overflow interrupts enabled
0 = TIMB overflow interrupts disabled
TSTOP — TIMB Stop Bit
This read/write bit stops the TIMB counter. Counting resumes when TSTOP is cleared. Reset sets the
TSTOP bit, stopping the TIMB counter until software clears the TSTOP bit.
1 = TIMB counter stopped
0 = TIMB counter active
NOTE
Do not set the TSTOP bit before entering wait mode if the TIMB is required
to exit wait mode. Also, when the TSTOP bit is set and the timer is
configured for input capture operation, input captures are inhibited until
TSTOP is cleared.
When using TSTOP to stop the timer counter, see if any timer flags are set.
If a timer flag is set, it must be cleared by clearing TSTOP, then clearing the
flag, then setting TSTOP again.
TRST — TIMB Reset Bit
Setting this write-only bit resets the TIMB counter and the TIMB prescaler. Setting TRST has no effect
on any other registers. Counting resumes from $0000. TRST is cleared automatically after the TIMB
counter is reset and always reads as logic 0. Reset clears the TRST bit.
1 = Prescaler and TIMB counter cleared
0 = No effect
NOTE
Setting the TSTOP and TRST bits simultaneously stops the TIMB counter
at a value of $0000.
MC68HC908AZ60A • MC68HC908AS60A • MC68HC908AS60E Data Sheet, Rev. 6
236
Freescale Semiconductor