UM10430 Datasheet, PDF (161/1164 Pages) NXP Semiconductors – LPC18xx ARM Cortex-M3 microcontroller

NXP Semiconductors
Table 107. Pin description …continued
Symbol
P9_4
N10 x - x -
P9_5
M9 x - x 69
P9_6
L11 x - x 72
PA_0
L12 x - x -
[3]
Reset
state
[2]
I; PU
UM10430 _Type
-
O
RMDeC—sOcF_Briu_0pn^t—ic^otiⁿo^C_Mn^h_ort^aeo^psre^t_c^erov^r_net¹dr^D_o.^2R_l^:A_P^LF_W^TPD_M^CR1A_c^D8_h^FRTx_a^A_n^xDF_n^TRP_e^AD_l^iFRn₀^TAD_,^DcFR_o^TRAo_u^AFDn_tp^TFRfT_u^AiDg_t^DFR_B^uTRDA_.^{ArRFDaTFARTtFADiToDFRTRDAnARDFTFDARTRFADTADFRTFRDATADRF}
O USB1_IND0 — USB1 Port indicator LED control output
0.
-
R — Function reserved.
I/O GPIO5[17] — General purpose digital input/output pin.
O ENET_TXD2 — Ethernet transmit data 2 (MII interface).
-
R — Function reserved.
I
U3_RXD — Receiver input for USART3.
[3] _{I; PU -}
R — Function reserved.
O MCOA1 — Motor control PWM channel 1, output A.
O USB1_VBUS_EN — USB1 VBUS power enable.
-
R — Function reserved.
I/O GPIO5[18] — General purpose digital input/output pin.
O ENET_TXD3 — Ethernet transmit data 3 (MII interface).
-
R — Function reserved.
O U0_TXD — Transmitter output for USART0.
[3] _{I; PU I/O GPIO4[11] — General purpose digital input/output pin.}
O MCOB1 — Motor control PWM channel 1, output B.
O USB1_PWR_FAULT — USB1 Port power fault signal
indicating over-current condition; this signal monitors
over-current on the USB1 bus (external circuitry required
to detect over-current condition).
-
R — Function reserved.
-
R — Function reserved.
I
ENET_COL — Ethernet Collision detect (MII interface).
-
R — Function reserved.
I
U0_RXD — Receiver input for USART0.
[3] _{I; PU -}
R — Function reserved.
-
R — Function reserved.
-
R — Function reserved.
-
R — Function reserved.
-
R — Function reserved.
O I2S1_RX_MCLK — I2S1 receive master clock.
O CGU_OUT1 — CGU spare clock output 1.
-
R — Function reserved.
<Document ID>
User manual
All information provided in this document is subject to legal disclaimers.
Rev. 00.13 — 20 July 2011
© NXP B.V. 2011. All rights reserved.
161 of 1164