MC68HC908EY16 Datasheet, PDF (273/278 Pages) Motorola, Inc – Microcontrollers

Section
Enhanced Serial
Communications
Interface (ESCI)
Module
Electrical Specifications
Page (in Rev 3.0)
233
237
382
383
Description of change
Extra paragraph added describing LINR bit functionality in LIN version 1.2
systems
‘SCI clock source’ changed to ‘Frequency of the SCI clock source’ in baud
rate equation and description
Output high voltage, I_LOAD=–10.0mA changed to –5.0mA
Output low voltage, I_LOAD=10.0mA changed to 5.0mA
Footnotes 11, 12 and 13 added
Changes from Rev 1.0 published on 17 April 2002 to Rev 2.0 published in May 2002
3V option removed.
PTB5 frequency divider function removed.
BEMF section moved from appendix to Section 18
.
Section
Page (in Rev 2.0)
Description of change
Memory Map
50
ESCIBDSRC bit added to CONFIG2
Configuration Registers
(CONFIG1 &
CONFIG2)
148
ESCIBDSRC bit added to CONFIG2 with bit description
Enhanced Serial
Communications
Interface (ESCI)
Module
200
Baud rate selection sentence added to sections 14.5 and 14.5.2 and after
Table 14-10.
Changes from Rev 0.4 published internally on 9 April 2002 to Rev 1.0 published
on 17 April 2002
Change in revision number only to denote external release version.
Changes from Rev 0.3 published on 6 September 2001 to Rev 0.4 published internally
on 9 April 2002
Section
Memory Map
FLASH Memory
System Integration
Module (SIM)
Configuration Registers
(CONFIG1 &
CONFIG2)
Monitor ROM (MON)
Page (in Rev 0.4)
43
62
65
92
149
169
170
170
171
Description of change
Reserved port register bits redefined as unimplemented
Note added about erasing last FLASH page
Removed last two sentences of FLASH Block Protection description
RST description added
PTB7 changed to PTC3
Table 10-1. Mode Selection added
Added sentence about forced monitor mode
Updated first note in section 10.5.1
PTB5 column added to Table 10-2
PTB5 pin added to Figure 10-1
MC68HC908EY16 • MC68HC908EY8 Data Sheet, Rev. 10
Freescale Semiconductor
273