MC68HC908EY16 Datasheet, PDF (163/278 Pages) Motorola, Inc – Microcontrollers

Program Exception Control
If more than one interrupt is pending at the end of an instruction execution, the highest priority interrupt is
serviced first. Figure 14-10 demonstrates what happens when two interrupts are pending. If an interrupt
is pending upon exit from the original interrupt service routine, the pending interrupt is serviced before the
load-accumulator- from-memory (LDA) instruction is executed.
CLI
LDA #$FF
BACKGROUND
ROUTINE
INT1
PSHH
PULH
RTI
INT1 INTERRUPT SERVICE ROUTINE
INT2
PSHH
INT2 INTERRUPT SERVICE ROUTINE
PULH
RTI
Figure 14-10. Interrupt Recognition Example
The LDA opcode is prefetched by both the INT1 and INT2 RTI instructions. However, in the case of the
INT1 RTI prefetch, this is a redundant operation.
NOTE
To maintain compatibility with the M6805, M146805, and MC68HC05
Families the H register is not pushed on the stack during interrupt entry. If
the interrupt service routine modifies the H register or uses the indexed
addressing mode, software should save the H register and then restore it
prior to exiting the routine.
14.5.1.2 SWI Instruction
The SWI instruction is a non-maskable instruction that causes an interrupt regardless of the state of the
interrupt mask (I bit) in the condition code register.
NOTE
A software interrupt pushes PC onto the stack. A software interrupt does
not push PC – 1, as a hardware interrupt does.
14.5.2 Reset
All reset sources always have higher priority than interrupts and cannot be arbitrated.
MC68HC908EY16 • MC68HC908EY8 Data Sheet, Rev. 10
Freescale Semiconductor
163