MC68HC908EY16 Datasheet, PDF (221/278 Pages) Motorola, Inc – Microcontrollers

I/O Registers
Setting MS0B disables the channel 1 status and control register and reverts TBCH1 to
general-purpose I/O.
Reset clears the MSxB bit.
1 = Buffered output compare/PWM operation enabled
0 = Buffered output compare/PWM operation disabled
MSxA — Mode Select Bit A
When ELSxB:A ≠ 00, this read/write bit selects either input capture operation or unbuffered output
compare/PWM operation. See Table 18-2.
1 = Unbuffered output compare/PWM operation
0 = Input capture operation
When ELSxB:A = 00, this read/write bit selects the initial output level of the TCHx pin once PWM, input
capture, or output compare operation is enabled. See Table 18-2. Reset clears the MSxA bit.
1 = Initial output level low
0 = Initial output level high
NOTE
Before changing a channel function by writing to the MSxB or MSxA bit, set
the TSTOP and TRST bits in the TIMB status and control register (TBSC).
ELSxB and ELSxA — Edge/Level Select Bits
When channel x is an input capture channel, these read/write bits control the active edge-sensing logic
on channel x.
When channel x is an output compare channel, ELSxB and ELSxA control the channel x output
behavior when an output compare occurs.
When ELSxB and ELSxA are both clear, channel x is not connected to port B, and pin PTBx/TBCHx
is available as a general-purpose I/O pin. However, channel x is at a state determined by these bits
and becomes transparent to the respective pin when PWM, input capture, or output compare mode is
enabled. Table 18-2 shows how ELSxB and ELSxA work. Reset clears the ELSxB and ELSxA bits.
Table 18-2. Mode, Edge, and Level Selection
MSxB
X
X
0
0
0
0
0
0
0
1
1
1
MSxA
0
1
0
0
0
1
1
1
1
X
X
X
ELSxB
0
0
0
1
1
0
0
1
1
0
1
1
ELSxA
0
0
1
0
1
0
1
0
1
1
0
1
Mode
Output preset
Input capture
Output compare
or PWM
Buffered output
compare or
buffered PWM
Configuration
Pin under port control; initial output level high
Pin under port control; initial output level low
Capture on rising edge only
Capture on falling edge only
Capture on rising or falling edge
Software compare only
Toggle output on compare
Clear output on compare
Set output on compare
Toggle output on compare
Clear output on compare
Set output on compare
NOTE
Before enabling a TIMB channel register for input capture operation, make
sure that the PTBx/TBCHx pin is stable for at least two bus clocks.
MC68HC908EY16 • MC68HC908EY8 Data Sheet, Rev. 10
Freescale Semiconductor
221