PIC18F2331_07 Datasheet, PDF (349/400 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with nanoWatt Technology, High Performance PWM and A/D

PIC18F2331/2431/4331/4431
25.3 DC Characteristics: PIC18F2331/2431/4331/4431 (Industrial)
PIC18LF2331/2431/4331/4431 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
Param
No.
Symbol
Characteristic
Min
Max Units
Conditions
VOL Output Low Voltage
D080
I/O Ports
—
0.6
V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
D083
VOH
OSC2/CLKO
(RC, RCIO, EC, ECIO modes)
Output High Voltage⁽³⁾
—
0.6
V IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
D090
I/O Ports
VDD – 0.7
—
V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D092
OSC2/CLKO
(RC, RCIO, EC, ECIO modes)
VDD – 0.7
—
V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D150 VOD Open-Drain High Voltage
—
8.5
V RA4 pin
Capacitive Loading Specs
on Output Pins
D100^{(4) COSC2 OSC2 pin}
—
15
pF In XT, HS and LP modes
when external clock is
used to drive OSC1
D101 CIO
D102 CB
All I/O pins and OSC2
(in RC mode)
SCL, SDA
—
50
pF To meet the AC Timing
Specifications
—
400
pF I²C™ Specification
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC^® device be driven with an external clock while in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: Parameter is characterized but not tested.
© 2007 Microchip Technology Inc.
Preliminary
DS39616C-page 347