PIC18F2331_07 Datasheet, PDF (192/400 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with nanoWatt Technology, High Performance PWM and A/D

PIC18F2331/2431/4331/4431
17.4.2 INTERRUPTS IN SINGLE-SHOT
MODE
When the PWM time base is in the Single-Shot mode
(PTMOD<1:0> = 01), an interrupt event is generated
when a match with the PTPER register occurs. The
PWM Time Base register (PTMR) is reset to zero on
the following input clock edge and the PTEN bit is
cleared. The postscaler selection bits have no effect in
this Timer mode.
17.4.3 INTERRUPTS IN CONTINUOUS
UP/DOWN COUNT MODE
In the Continuous Up/Down Count mode
(PTMOD<1:0> = 10), an interrupt event is generated
each time the value of the PTMR register becomes
zero and the PWM time base begins to count upwards.
The postscaler selection bits may be used in this mode
of the timer to reduce the frequency of the interrupt
events. Figure 17-7 shows the interrupts in Continuous
Up/Down Count mode.
FIGURE 17-6:
PWM TIME BASE INTERRUPT TIMING, SINGLE-SHOT MODE
A: PRESCALER = 1:1
Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4 Q1 Q2 Q3 Q4
FOSC/4
PTMR
FFEh
2
FFFh
000h
000h
000h
1
1
1
PTMR_INT_REQ
PTIF bit
B: PRESCALER = 1:4
Q4 Q4
Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc Qc
PTMR
1
PTMR_INT_REQ
FFEh
2
FFFh
1
000h
1
000h
000h
PTIF bit
Note 1: Interrupt flag bit, PTIF, is sampled here (every Q1).
2: PWM Time Base Period register, PTPER, is loaded with the value FFFh for this example.
DS39616C-page 190
Preliminary
© 2007 Microchip Technology Inc.