PIC18F2331_07 Datasheet, PDF (149/400 Pages) Microchip Technology – 28/40/44-Pin Enhanced Flash Microcontrollers with nanoWatt Technology, High Performance PWM and A/D

PIC18F2331/2431/4331/4431
14.0 TIMER5 MODULE
The Timer5 module implements these features:
• 16-bit timer/counter operation
• Synchronous and Asynchronous Counter modes
• Continuous Count and Single-Shot Operating modes
• Four programmable prescaler values (1:1 to 1:8)
• Interrupt generated on period match
• Special Event Trigger Reset function
• Double-buffered registers
• Operation during Sleep
• CPU wake-up from Sleep
• Selectable hardware Reset input with a wake-up
feature
Timer5 is a general purpose timer/counter that incor-
porates additional features for use with the Motion
Feedback Module (see Section 16.0 “Motion Feed-
back Module”). It may also be used as a general
purpose timer or a Special Event Trigger delay timer.
When used as a general purpose timer, it can be
configured to generate a delayed Special Event Trigger
(e.g., an ADC Special Event Trigger) using a
preprogrammed period delay.
Timer5 is controlled through the Timer5 Control register
(T5CON), shown in Register 14-1. The timer can be
enabled or disabled by setting or clearing the control bit
TMR5ON (T5CON<0>).
A block diagram of Timer5 is shown in Figure 14-1.
REGISTER 14-1: T5CON: TIMER5 CONTROL REGISTER
R/W-0
T5SEN
bit 7
R/W-0
RESEN⁽¹⁾
R/W-0
T5MOD
R/W-0
T5PS1
R/W-0
T5PS0
R/W-0
T5SYNC⁽²⁾
R/W-0
TMR5CS
R/W-0
TMR5ON
bit 0
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
‘1’ = Bit is set
U = Unimplemented bit, read as ‘0’
‘0’ = Bit is cleared
x = Bit is unknown
bit 7
bit 6
bit 5
bit 4-3
bit 2
bit 1
bit 0
T5SEN: Timer5 Sleep Enable bit
1 = Timer5 enabled during Sleep
0 = Timer5 disabled during Sleep
RESEN: Special Event Trigger Reset Enable bit⁽¹⁾
1 = Special Event Trigger Reset disabled
0 = Special Event Trigger Reset enabled
T5MOD: Timer5 Mode bit
1 = Single-Shot mode enabled
0 = Continuous Count mode enabled
T5PS1:T5PS0: Timer5 Input Clock Prescale Select bits
11 = 1:8
10 = 1:4
01 = 1:2
00 = 1:1
T5SYNC: Timer5 External Clock Input Synchronization Select bit⁽²⁾
When TMR5CS = 1:
1 = Do not synchronize external clock input
0 = Synchronize external clock input
When TMR5CS = 0:
This bit is ignored. Timer5 uses the internal clock when TMR5CS = 0.
TMR5CS: Timer5 Clock Source Select bit
1 = External clock from pin T5CKI
0 = Internal clock (TCY)
TMR5ON: Timer5 On bit
1 = Timer5 enabled
0 = Timer5 disabled
Note 1: These bits are not implemented on PIC18F2331/2431 devices and read as ‘0’.
2: For Timer5 to operate during Sleep mode, T5SYNC must be set.
© 2007 Microchip Technology Inc.
Preliminary
DS39616C-page 147