PIC24EP256GU810-I Datasheet, PDF (602/622 Pages) Electronic Film Capacitors, Inc. – 16-Bit Microcontrollers and Digital Signal Controllers with High-Speed PWM, USB and Advanced Analog

dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814
TABLE A-2: MAJOR SECTION UPDATES (CONTINUED)
Section Name
Update Description
Section 21.0 “Enhanced CAN
(ECAN™) Module”
Section 22.0 “USB On-The-Go
(OTG) Module”
Section 23.0 “10-bit/12-bit
Analog-to-Digital Converter
(ADC)”
Section 29.0 “Special Features”
Added the CANCKS bit to the ECAN Control Register 1 (CiCTRL1)
(see Register 21-1).
Removed the USB 3.3V Regulator logic from the USB Interface Diagram
(see Figure 22-1).
Updated the ADC Conversion Clock Period Block Diagram (see Figure 23-2).
Updated the last paragraph of Section 29.1 “Configuration Bits”
Added a note box after the last paragraph of Section 29.3 “BOR: Brown-out
Reset (BOR)”.
Section 30.0 “Instruction Set
Summary”
Section 32.0 “Electrical
Characteristics”
Added the RTSP Effect column to the Configuration Bits Description
(see Table 29-2).
Updated all Status Flags Affected to None for the MOV instruction and added
Note 2 (see Table 30-2).
Updated the Absolute Maximum Ratings (see page 457).
Added Note 1 to the Operating MIPS vs. Voltage (see Table 32-1).
Added parameter DI31 (ICNPD) to the I/O Pin Input Specifications (see
Table 32-9).
Updated the Minimum value for parameter DO26 in the I/O Pin Output
Specifications (see Table 32-10).
Updated the Minimum value for parameter D132b and the Minimum and
Maximum values for parameters D136a, D136b, D137a, D137b, D138a, and
D138b in the Program Memory specification (see Table 32-12).
Updated the Minimum, Typical, and Maximum values for parameter OS10
(Oscillator Crystal Frequency: SOSC) in the External Clock Timing
Requirements (see Table 32-16).
Added Note 2 to the PLL Clock Timing Specifications (see Table 32-17).
Updated all Timer1 External Clock Timing Requirements (see Table 32-23).
Replaced Table 32-34 with Timer2, Timer4, Timer6, Timer8 External Clock
Timing Requirements and Timer3, Timer5, Timer7, Timer9 External Clock
Timing Requirements (see Table 32-24 and Table 32-25, respectively).
Updated the Maximum value for parameter OC15 and the Minimum value for
parameter OC20 in the OC/PWM Mode Timing Requirements
(see Table 32-29).
Updated the Operating Temperature in the ECAN Module I/O Timing
Requirements and USB OTG Timing Requirements (see Table 32-51 and
Table 32-53, respectively).
Updated all SPI specifications (see Figure 32-15 through Figure 32-30 and
Table 32-33 through Table 32-48).
Removed Note 4 from the DCI Module Timing Requirements
(see Table 32-59).
Updated the Standard Operating Conditions voltage for the Comparator
Specifications (see Table 32-61 through Table 32-64).
DS70616G-page 602
 2009-2012 Microchip Technology Inc.