PIC24EP256GU810-I Datasheet, PDF (508/622 Pages) Electronic Film Capacitors, Inc. – 16-Bit Microcontrollers and Digital Signal Controllers with High-Speed PWM, USB and Advanced Analog

dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814
TABLE 32-9: DC CHARACTERISTICS: I/O PIN INPUT SPECIFICATIONS (CONTINUED)
DC CHARACTERISTICS
Standard Operating Conditions: 3.0V to 3.6V
(unless otherwise stated)
Operating temperature -40°C  TA  +85°C for Industrial
-40°C  TA  +125°C for Extended
Param. Symbol
Characteristic
Min.
Typ⁽¹⁾ Max. Units
Conditions
IICL
Input Low Injection Current
DI60a
All pins except VDD,
VSS, AVDD, AVSS,
0
—
-5^(5,8) mA MCLR, VCAP, RB11,
SOSCI, SOSCO, D+,
D-, VUSB3V3 and VBUS
IICH
Input High Injection Current
DI60b
All pins except VDD,
VSS, AVDD, AVSS,
MCLR, VCAP, RB11,
0
— +5^(6,7,4) mA SOSCI, SOSCO, D+,
D-, VUSB3V3 and VBUS,
and all 5V tolerant
pins⁽⁷⁾
IICT
DI60c
Total Input Injection Current
(sum of all I/O and control
pins)
-20⁽⁹⁾
—
+20⁽⁹⁾ mA Absolute instantaneous
sum of all ± input
injection currents from
all I/O pins
( | IICL + | IICH | )  IICT
Note 1: Data in “Typ” column is at 3.3V, +25°C unless otherwise stated.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current can be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.
4: See “Pin Diagrams” for the 5V tolerant I/O pins.
5: VIL source < (VSS – 0.3). Characterized but not tested.
6: Non-5V tolerant pins VIH source > (VDD + 0.3), 5V tolerant pins VIH source > 5.5V. Characterized but not
tested.
7: Digital 5V tolerant pins cannot tolerate any “positive” input injection current from input sources > 5.5V.
8: Injection currents > | 0 | can affect the ADC results by approximately 4-6 counts.
9: Any number and/or combination of I/O pins not excluded under IICL or IICH conditions are permitted, pro-
vided the mathematical “absolute instantaneous” sum of the input injection currents from all pins do not
exceed the specified limit. Characterized but not tested.
10: These parameters are characterized, but not tested.
DS70616G-page 508
 2009-2012 Microchip Technology Inc.