English
Language : 

PIC24EP256GU810-I Datasheet, PDF (301/622 Pages) Electronic Film Capacitors, Inc. – 16-Bit Microcontrollers and Digital Signal Controllers with High-Speed PWM, USB and Advanced Analog
dsPIC33EPXXX(GP/MC/MU)806/810/814 and PIC24EPXXX(GP/GU)810/814
REGISTER 16-5: STCON: PWM SECONDARY MASTER TIME BASE CONTROL REGISTER
U-0
—
bit 15
U-0
U-0
HSC-0
R/W-0
R/W-0
R/W-0
R/W-0
—
—
SESTAT
SEIEN
EIPU(1)
SYNCPOL SYNCOEN
bit 8
R/W-0
SYNCEN
bit 7
R/W-0
R/W-0
R/W-0
SYNCSRC<2:0>
R/W-0
R/W-0
R/W-0
SEVTPS<3:0>
R/W-0
bit 0
Legend:
R = Readable bit
-n = Value at POR
HSC = Set or Cleared in Hardware
W = Writable bit
U = Unimplemented bit, read as ‘0’
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 15-13
bit 12
bit 11
bit 10
bit 9
bit 8
bit 7
bit 6-4
bit 3-0
Unimplemented: Read as ‘0’
SESTAT: Special Event Interrupt Status bit
1 = Secondary special event interrupt is pending
0 = Secondary special event interrupt is not pending
SEIEN: Special Event Interrupt Enable bit
1 = Secondary special event interrupt is enabled
0 = Secondary special event interrupt is disabled
EIPU: Enable Immediate Period Updates bit(1)
1 = Active Secondary Period register is updated immediately
0 = Active Secondary Period register updates occur on PWM cycle boundaries
SYNCPOL: Synchronize Input and Output Polarity bit
1 = The falling edge of SYNCIN resets the SMTMR; SYNCO2 output is active-low
0 = The rising edge of SYNCIN resets the SMTMR; SYNCO2 output is active-high
SYNCOEN: Secondary Master Time Base Synchronization Enable bit
1 = SYNCO2 output is enabled
0 = SYNCO2 output is disabled
SYNCEN: External Secondary Master Time Base Synchronization Enable bit
1 = External synchronization of secondary time base is enabled
0 = External synchronization of secondary time base is disabled
SYNCSRC<2:0>: Secondary Time Base Synchronization Source Selection bits
111 = Reserved
•
•
•
010 = Reserved
001 = SYNCI2
000 = SYNCI1
SEVTPS<3:0>: PWM Secondary Special Event Trigger Output Postscaler Select bits
1111 = 1:16 Postcale
•
•
•
0001 = 1:2 Postcale
0000 = 1:1 Postscale
Note 1: This bit only applies to the secondary master time base period.
 2009-2012 Microchip Technology Inc.
DS70616G-page 301