Z8FMC16100 Datasheet, PDF (50/402 Pages) Zilog, Inc. – Z8 Encore-R Motor Control Flash MCUs

Z8 Encore!^® Motor Control Flash MCUs
Product Specification
28
Stop-Mode Recovery
STOP mode is entered by execution of a STOP instruction by the eZ8 CPU. Refer to the
Low-Power Modes chapter on page 31 for detailed STOP mode information. During Stop-
Mode Recovery, the device is held in reset for 66 cycles of the Internal Precision Oscilla-
tor. Stop-Mode Recovery only affects the contents of the Reset Status and Control Regis-
ter and Oscillator Control Register. Stop-Mode Recovery does not affect any other values
in the Register File, including the Stack Pointer, Register Pointer, Flags, peripheral control
registers, and general-purpose RAM.
The eZ8 CPU fetches the Reset vector at Program Memory addresses 0002h and 0003h
and loads that value into the Program Counter. Program execution begins at the Reset vec-
tor address. Following Stop-Mode Recovery, the STOP bit in the Reset Status and Control
Register is set to 1. Table 8 lists the Stop-Mode Recovery sources and resulting actions.
The text following provides more detailed information on each of the Stop-Mode Recov-
ery sources
Table 8. Stop-Mode Recovery Sources and Resulting Action
Operating Mode
Stop Mode
Stop-Mode Recovery Source
Watch-Dog Timer time-out when
configured for Reset
Watch-Dog Timer time-out when
configured for System Exception
Data transition on any GPIO port pin
enabled as a Stop-Mode Recovery
source
Action
Stop-Mode Recovery
Stop-Mode Recovery followed by WDT
System Exception
Stop-Mode Recovery
Stop-Mode Recovery Using Watch-Dog Timer Time-Out
If the Watch-Dog Timer times out during STOP mode, the device undergoes a Stop-Mode
Recovery sequence. In the Reset Status and Control Register, the WDT and STOP bits are
set to 1. If the Watch-Dog Timer is configured to generate a System Exception upon time-
out, the eZ8 CPU services the Watch-Dog Timer System Exception following the normal
Stop-Mode Recovery sequence.
Stop-Mode Recovery Using a GPIO Port Pin Transition
Each of the GPIO port pins may be configured as a Stop-Mode Recovery input source. On
any GPIO pin enabled as a Stop-Mode Recovery source, a change in the input pin value
(from High to Low or from Low to High) initiates Stop-Mode Recovery. The GPIO Stop-
Mode Recovery signals are filtered to reject pulses less than 10ns (typical) in duration. In
the Reset Status and Control Register, the STOP bit is set to 1.
Reset and Stop-Mode Recovery
PRELIMINARY
PS024604-1005