Z8FMC16100 Datasheet, PDF (182/402 Pages) Zilog, Inc. – Z8 Encore-R Motor Control Flash MCUs

Z8 Encore!^® Motor Control Flash MCUs
Product Specification
160
TXST—Transmit Status
0 = No data transmission currently in progress.
1 = Data transmission currently in progress.
SLAS—Slave Select
If SPI enabled as a Slave,
0 = SS input pin is asserted (Low)
1 = SS input is not asserted (High).
If SPI enabled as a Master, this bit is not applicable.
SPI Mode Register
The SPI Mode Register configures the character bit width and the direction and value of
the SS pin.
BITS
FIELD
RESET
R/W
ADDR
Table 87. SPI Mode Register (SPIMODE)
7
6
Reserved
5
DIAG
4
3
2
NUMBITS[2:0]
00H
R
R/W
F63H
1
0
SSIO
SSV
Reserved—Must be 0.
DIAG - Diagnostic Mode Control bit
This bit is for SPI diagnostics. Setting this bit allows the Baud Rate Generator value to be
read using the SPIBRH and SPIBRL register locations.
0 = Reading SPIBRH, SPIBRL returns the value in the SPIBRH and SPIBRL registers
1 = Reading SPIBRH returns bits [15:8] of the SPI Baud Rate Generator; and reading SPI-
BRL returns bits [7:0] of the SPI Baud Rate Counter. The Baud Rate Counter High and
Low byte values are not buffered.
Caution:
Exercise caution if reading the values while the BRG is counting.
NUMBITS[2:0]—Number of Data Bits Per Character to Transfer
This field contains the number of bits to shift for each character transfer. Refer to the SPI
Data Register description for information on valid bit positions when the character length
is less than 8-bits.
Serial Peripheral Interface
PRELIMINARY
PS024604-1005