Z8FMC16100 Datasheet, PDF (183/402 Pages) Zilog, Inc. – Z8 Encore-R Motor Control Flash MCUs

Z8FMC16100 Series Flash MCU
Product Specification
161
000 = 8 bits
001 = 1 bit
010 = 2 bits
011 = 3 bits
100 = 4 bits
101 = 5 bits
110 = 6 bits
111 = 7 bits
SSIO—Slave Select I/O
0 = SS pin configured as an input.
1 = SS pin configured as an output (MASTER mode only).
SSV—Slave Select Value
If SSIO = 1 and SPI configured as a Master:
0 = SS pin driven Low (0).
1 = SS pin driven High (1).
This bit has no effect if SSIO = 0 or SPI configured as a Slave
SPI Diagnostic State Register
The SPI Diagnostic State Register provides observability of internal state. It is a read-only
register used for SPI diagnostics. More detail about each bit follows the table.
Table 88. SPI Diagnostic State Register (SPIDST)
BITS
7
6
5
4
3
2
1
0
FIELD ^{SCKEN TCKEN}
SPISTATE
RESET
00H
R/W
R
ADDR
F64H
SCKEN - Shift Clock Enable
0 = The internal Shift Clock Enable signal is deasserted
1 = The internal Shift Clock Enable signal is asserted (shift register is updates on next sys-
tem clock)
TCKEN - Transmit Clock Enable
0 = The internal Transmit Clock Enable signal is deasserted.
1 = The internal Transmit Clock Enable signal is asserted. When this is asserted the serial
data out is updated on the next system clock (MOSI or MISO).
PS024604-1005
PRELIMINARY
SPI Diagnostic State Register