Z8FMC16100 Datasheet, PDF (101/402 Pages) Zilog, Inc. – Z8 Encore-R Motor Control Flash MCUs

Z8FMC16100 Series Flash MCU
Product Specification
79
Bit
Position
[7]
PWMOFF
Value
(H)
0
1
[6]
OUTCTL 0
1
[5]
ALIGN
0
1
[4]
Reserved
[3]
ADCTRIG 0
1
[2]
Reserved 0
[1]
READY
0
1
[0]
PWMEN 0
1
Description
Place PWM outputs in off-state
Disable modulator control of PWM pins. Outputs are in predefined off-state. This
is not dependent on the reload event.
Re-enable modulator control of PWM pins at next PWM reload event.
PWM Output Control
PWM outputs are controlled by the Pulse-Width Modulator.
PWM outputs selectively disabled (set to off-state) according to values in the
OUTx bits of the PWMOUT register.
PWM Edge Alignment
PWM outputs are edge aligned.
PWM outputs are center aligned.
Reserved
ADC Trigger Enable
No ADC trigger pulses.
ADC trigger enabled.
Reserved
Values Ready for Next Reload Event
PWM values (pre-scale, period, and duty cycle) are not ready. Do not use
values in holding registers at next PWM reload event
PWM values (pre-scale, period, and duty cycle) are ready. Transfer all values
from temporary holding registers to working registers at next PWM reload event.
PWM Enable
Pulse-width modulator is disabled and enabled PWM output pins are forced to
default off-state. PWM master counter is stopped. Certain control registers may
only written in this state.
Pulse-width modulator is enabled and PWM output pins are enabled as outputs.
PS024604-1005
PRELIMINARY
PWM Control 0 Register