Z8FMC16100 Datasheet, PDF (207/402 Pages) Zilog, Inc. – Z8 Encore-R Motor Control Flash MCUs

Z8FMC16100 Series Flash MCU
Product Specification
185
BITS
FIELD
RESET
R/W
ADDR
Table 93. I²C Interrupt Status Register (I2CISTAT)
7
TDRE
1
R
6
RDRF
0
R
5
SAM
0
R
4
3
GCA
RD
0
0
R
R
F51H
2
ARBLST
0
R
1
SPRS
0
R
0
NCKI
0
R
TDRE—Transmit Data Register Empty
When the I²C Controller is enabled, this bit is 1 when the I²C Data register is empty.
When set, this bit causes the I²C Controller to generate an interrupt, except when the I²C
Controller is shifting in data during the reception of a byte or when shifting an address and
the RD bit is set. This bit clears by writing to the I2CDATA register.
RDRF—Receive Data Register Full
This bit is set = 1 when the I²C Controller is enabled and the I²C Controller has received a
byte of data. When asserted, this bit causes the I²C Controller to generate an interrupt.
This bit clears by reading the I2CDATA register.
SAM—Slave Address Match
This bit is set = 1 if the I²C Controller is enabled in Slave mode and an address is received
which matches the unique Slave address or General Call Address (if enabled by the GCE
bit in the I²C Mode register). In 10-bit addressing mode, this bit is not set until a match is
achieved on both address bytes. When this bit is set, the RD and GCA bits are also valid.
This bit clears by reading the I2CISTAT register.
GCA—General Call Address
This bit is set in Slave mode when the General Call Address or START byte is recognized
(in either 7 or 10 bit Slave mode). The GCE bit in the I²C Mode register must be set to
enable recognition of the General Call Address and START byte. This bit clears when IEN
= 0 and is updated following the first address byte of each Slave mode transaction. A Gen-
eral Call Address is distinguished from a START byte by the value of the RD bit (RD = 0
for General Call Address, 1 for START byte).
RD—Read
This bit indicates the direction of transfer of the data. It is set when the Master is reading
data from the Slave. This bit matches the least-significant bit of the address byte after the
START condition occurs (for both Master and Slave modes). This bit clears when IEN = 0
and is updated following the first address byte of each transaction.
ARBLST—Arbitration Lost
This bit is set when the I²C Controller is enabled in Master mode and loses arbitration
(outputs a 1 on SDA and receives a 0 on SDA). The ARBLST bit clears when the
I2CISTAT register is read.
PS024604-1005
PRELIMINARY
I2C Interrupt Status Register