Z8FMC16100 Datasheet, PDF (248/402 Pages) Zilog, Inc. – Z8 Encore-R Motor Control Flash MCUs

Z8 Encore!^® Motor Control Flash MCUs
Product Specification
226
Bit
Position
[7]
FLTSEL
[6]
LPDEN
[5]
Reserved
[4]
PWM2EN
[3]
PWM1EN
[2]
PWM0EN
[1]
PWMHI
[0]
PWMLO
Value
(H)
0
1
0
1
0
1
0
1
0
1
0
1
0
1
Description
RESET/Fault0 Select
RESET/Fault0 pin is configured as Fault0 input.
RESET/Fault0 pin is configured as RESET input.
Low Power Divide Mode Enable. See Oscillator Control chapter on page 231.
Low Power Divide mode is enabled
Low Power Divide mode is disabled
Must be 1.
This Option Bit is reserved for future use and must always be 1.
PWM Output Pair PWM2 Enable
PWM2 outputs are enabled and controlled by PWM logic.
PWM2 outputs are always high-impedance.
PWM Output Pair PWM1 Enable
PWM1 outputs are enabled and controlled by PWM logic.
PWM1 outputs are always high-impedance.
PWM Output Pair PWM0 Enable
PWM0 outputs are enabled and controlled by PWM logic.
PWM0 outputs are always high-impedance.
PWM High Side (PWM outputs 0H,1H, 2H) Default Off-State
PWM High-side inactive state is low, active state is High.
PWM High-side inactive state is high, active state is Low.
PWM Low Side (PWM outputs 0L,1L, 2L) Default Off-State
PWM Low-side inactive state is low, active state is high.
PWM Low-side inactive state is high, active state is low.
Option Bits
PRELIMINARY
PS024604-1005