Z8FMC16100 Datasheet, PDF (282/402 Pages) Zilog, Inc. – Z8 Encore-R Motor Control Flash MCUs

Z8 Encore!^® Motor Control Flash MCUs
Product Specification
260
Table 139. DC Characteristics (Continued)
Symbol Parameter
T_A = –40ºC to 105ºC
Minimum Typical² Maximum Units Conditions
I_TL
Tri-State Leakage Current –5
—
+5
µA V_DD = 3.3V.
I_PU1
Weak Pull-up Current
9
20
50
µA V_DD = 2.7–3.6V.
T_A = 0ºC to +70ºC.
I_PU2
Weak Pull-up Current
7
20
75
µA V_DD = 2.7–3.6V.
T_A = –40ºC to +105ºC.
Idd
Chip leakage current in
stop1 STOP mode
2
uA STOP mode with VBO
disabled, WDT enabled.
Idd
Chip leakage current in
stop2 STOP mode
<1
uA STOP mode with VBO
and WDT disabled.
Notes:
1. This condition excludes all pins that have on-chip pull-ups, when driven Low.
2. These values are provided for design guidance only and are not tested in production.
Note:
Figure 45 illustrates the typical active mode current consumption while operating at 25ºC,
3.3 V, versus the system clock frequency. All GPIO pins are configured as outputs and
driven High.
Figures 45 through 50 are not yet available. At this time, the Z8FMC16100 Series Flash
MCU is not fully characterized.
Electrical Characteristics
PRELIMINARY
PS024604-1005