4524_M Datasheet, PDF (75/310 Pages) Renesas Technology Corp – 4-BIT CISC SINGLE-CHIP MICROCOMPUTER 720 FAMILY / 4500 SERIES

4524 Group
HARDWARE
FUNCTION BLOCK OPERATIONS
RESET FUNCTION
System reset is performed by applying “L” level to RESET pin for
1 machine cycle or more when the following condition is satisfied;
the value of supply voltage is the minimum value or more of the
recommended operating conditions.
Then when “H” level is applied to RESET pin, program starts from
address 0 in page 0.
f(XIN)
RESET
On-chip oscillator (internal oscillator)
is counted 5400 to 5424 times.
Program starts
(address 0 in page 0)
Note: The number of clock cycles depends on the internal state of
the microcomputer when reset is performed.
Fig. 47 Reset release timing
Reset input
1 machine cycle or more
On-chip oscillator (internal oscillator) is
counted 5400 to 5424 times.
0.85VDD
RESET
0.3VDD
Program starts
(address 0 in page 0)
(Note)
Note: Keep the value of supply voltage to the minimum value
or more of the recommended operating conditions.
Fig. 48 RESET pin input waveform and reset operation
Rev.2.00 Aug, 06 2004
REJ09B0107-0200Z
1-62