M1A3P1000-1PQ208M Datasheet, PDF (61/212 Pages) Microsemi Corporation – Military ProASIC3/EL Low Power Flash FPGAs with Flash*Freeze Technology

Military ProASIC3/EL Low Power Flash FPGAs
Timing Characteristics
1.2 V DC Core Voltage
Table 2-61 • 3.3 V LVCMOS Wide Range Low Slew
Military-Case Conditions: T_J = 125°C, Worst-Case VCC = 1.14 V, Worst-Case VCCI = 2.7 V
Applicable to Pro I/Os for A3PE600L and A3PE3000L Only
Drive
Strength
100 µA
Equiv.
Software
Default
Drive
Strength
Option¹
4 mA
Speed
Grade t_DOUT t_DP t_DIN t_PY
Std. 0.80 9.08 0.05 2.18
t_PYS t_EOUT t_ZL t_ZH t_LZ t_HZ t_ZLS t_ZHS Units
3.16 0.52 9.08 7.17 3.85 3.40 11.28 9.38 ns
–1 0.68 7.72 0.05 1.86 2.69 0.44 7.72 6.10 3.28 2.89 9.60 7.98 ns
100 µA
8 mA
Std. 0.80 7.37 0.05 2.18 3.16 0.52 7.37 6.10 4.38 4.35 9.58 8.31 ns
–1 0.68 6.27 0.05 1.86 2.69 0.44 6.27 5.19 3.73 3.70 8.15 7.07 ns
100 µA
12 mA
Std. 0.80 6.17 0.05 2.18 3.16 0.52 6.17 5.30 4.73 4.94 8.37 7.51 ns
–1 0.68 5.24 0.05 1.86 2.69 0.44 5.24 4.51 4.03 4.20 7.12 6.38 ns
100 µA
16 mA
Std. 0.80 5.82 0.05 2.18 3.16 0.52 5.82 5.12 4.80 5.11 8.03 7.33 ns
–1 0.68 4.95 0.05 1.86 2.69 0.44 4.95 4.36 4.09 4.34 6.83 6.23 ns
100 µA
24 mA Std. 0.80 5.64 0.05 2.18 3.16 0.52 5.64 5.14 4.90 5.72 7.85 7.35 ns
–1 0.68 4.80 0.05 1.86 2.69 0.44 4.80 4.38 4.17 4.87 6.67 6.25 ns
Notes:
1. Note that 3.3 V LVCMOS wide range is applicable to 100 µA drive strength only. The configuration will not operate at the
equivalent software default drive strength. These values are for normal ranges ONLY.
2. For specific junction temperature and voltage supply levels, refer to Table 2-5 on page 2-8 for derating values.
Table 2-62 • 3.3 V LVCMOS Wide Range High Slew
Military-Case Conditions: T_J = 125°C, Worst-Case VCC = 1.14 V, Worst-Case VCCI = 2.7 V
Applicable to Pro I/O Banks for A3PE600L and A3PE3000L Only
Drive
Strength
100 µA
Equiv.
Software
Default
Drive
Strength
Option¹
4 mA
Speed
Grade
Std.
t_DOUT t_DP t_DIN t_PY t_PYS t_EOUT t_ZL
0.80 5.00 0.05 2.18 3.16 0.52 5.00
t_ZH t_LZ t_HZ t_ZLS
3.77 3.85 3.62 7.21
t_ZHS Units
5.97 ns
–1 0.68 4.25 0.05 1.86 2.69 0.44 4.25 3.21 3.28 3.08 6.13 5.08 ns
100 µA
8 mA
Std. 0.80 4.07 0.05 2.18 3.16 0.52 4.07 2.98 4.38 4.57 6.27 5.19 ns
–1 0.68 3.46 0.05 1.86 2.69 0.44 3.46 2.54 3.73 3.89 5.33 4.41 ns
100 µA 12 mA
Std. 0.80 3.54 0.05 2.18 3.16 0.52 3.54 2.60 4.73 5.19 5.74 4.81 ns
–1 0.68 3.01 0.05 1.86 2.69 0.44 3.01 2.22 4.03 4.42 4.89 4.09 ns
100 µA
16 mA
Std. 0.80 3.45 0.05 2.18 3.16 0.52 3.45 2.54 4.82 5.36 5.66 4.74 ns
–1 0.68 2.94 0.05 1.86 2.69 0.44 2.94 2.16 4.10 4.56 4.81 4.03 ns
100 µA 24 mA
Std. 0.80 3.49 0.05 2.18 3.16 0.52 3.49 2.44 4.91 5.98 5.69 4.64 ns
–1 0.68 2.97 0.05 1.86 2.69 0.44 2.97 2.07 4.18 5.08 4.84 3.95 ns
Notes:
1. Note that 3.3 V LVCMOS wide range is applicable to 100 µA drive strength only. The configuration will not operate at the
equivalent software default drive strength. These values are for normal ranges only.
2. For specific junction temperature and voltage supply levels, refer to the Table 2-5 on page 2-8 for derating values.
3. Software default selection highlighted in gray.
Revision 3
2- 47