M1A3P1000-1PQ208M Datasheet, PDF (54/212 Pages) Microsemi Corporation – Military ProASIC3/EL Low Power Flash FPGAs with Flash*Freeze Technology

Military ProASIC3/EL DC and Switching Characteristics
Table 2-47 • Minimum and Maximum DC Input and Output Levels
Applicable to Standard Plus I/O Banks for A3P250 and A3P1000 Only
3.3 V LVTTL /
3.3 V LVCMOS
Drive Strength
VIL
Min.
V
Max.
V
VIH
Min.
V
Max.
V
VOL
Max.
V
VOH
Min.
V
I_OL I_OH
mA mA
I_OSL
Max.
mA³
I_OSH
Max.
mA³
I_IL1 I_IH2
µA⁴ µA⁴
2 mA
–0.3 0.8
2
3.6
0.4
2.4 2 2
25
27
15 15
4 mA
–0.3 0.8
2
3.6
0.4
2.4 4 4
25
27
15 15
6 mA
–0.3 0.8
2
3.6
0.4
2.4 6 6
51
54
15 15
8 mA
–0.3 0.8
2
3.6
0.4
2.4 8 8
51
54
15 15
12 mA
–0.3 0.8
2
3.6
0.4
2.4 12 12
103
109
15 15
16 mA
–0.3 0.8
2
3.6
0.4
2.4 16 16
103
109
15 15
Notes:
1. I_IL is the input leakage current per I/O pin over recommended operation conditions where –0.3V < VIN < VIL.
2. I_IH is the input leakage current per I/O pin over recommended operating conditions VIH < VIN < VCCI. Input current is
larger when operating outside.
3. Currents are measured at 100°C junction temperature and maximum voltage.
4. Currents are measured at 125°C junction temperature.
5. Software default selection highlighted in gray.
Test Point
Datapath
5 pF
R=1k
Test Point
Enable Path
R to VCCI for t_LZ / t_ZL / t_ZLS
R to GND for t_HZ / t_ZH / t_ZHS
5 pF for t_ZH / t_ZHS / t_ZL / t_ZLS
5 pF for t_HZ / t_LZ
Figure 2-8 • AC Loading
Table 2-48 • AC Waveforms, Measuring Points, and Capacitive Loads
Input Low (V)
Input High (V)
Measuring Point* (V)
VREF (Typ) (V)
0
3.3
1.4
–
Note: *Measuring point = V_trip. See Table 2-28 on page 2-27 for a complete table of trip points.
C_LOAD (pF)
5
2-40
Revision 3