M1A3P1000-1PQ208M Datasheet, PDF (207/212 Pages) Microsemi Corporation – Military ProASIC3/EL Low Power Flash FPGAs with Flash*Freeze Technology

Revision
Revision 1
(continued)
Military ProASIC3/EL Low Power Flash FPGAs
Changes
Page
The AC Loading diagrams in the "Single-Ended I/O Characteristics" section were 2-39
updated to match summary of I/O timing tables in the "Summary of I/O Timing
Characteristics – Default I/O Software Settings" section (SAR 32449).
The tables in the "Voltage-Referenced I/O Characteristics" section and "Differential I/O 2-75
Characteristics" section were updated with current values (SARs 29793, 32391, 32394). _2-87
Two note references were added to Table 2-159 • Minimum and Maximum DC Input and 2-88
Output Levels to clarify the following notes: ±5% [VCCI] and differential input voltage =
±350 mV [VDIFF] (SAR 29428).
The "Global Tree Timing Characteristics" section was updated.
Table 2-198 • A3P250 Global Resource is new (SAR 30526).
Available values were added or revised in the following tables (SAR 30698):
Table 2-194 • A3PE600L Global Resource
Table 2-199 • A3P1000 Global Resource
Table 2-196 • A3PE600L Global Resource
2-12
2
Table 2-200 • Military ProASIC3/EL CCC/PLL Specification and Table 2-201 • Military 2-12
ProASIC3/EL CCC/PLL Specification were updated with current values (SAR 32521).
5
The following figures were removed (SAR 29991):
N/A
Figure 2-49 • Write Access after Write onto Same Address
Figure 2-50 • Read Access after Write onto Same Address
Figure 2-51 • Write Access after Read onto Same Address
The naming of the address collision parameters in the SRAM "Timing Characteristics" 2-13
section was changed, and values were updated accordingly (SAR 29991).
1
The values for t_CKQ1 in Table 2-202 • RAM4K9, Table 2-203 • RAM4K9, and Table 2-204
• RAM4K9 were reversed with respect to WMODE and have been corrected (SAR
32343).
2-13
1,
2-13
2,
2-13
3
Table 2-211 • FIFO through Table 2-215 • FIFO are new (SAR 32394).
2-14
3,
2-14
7
Tables in the "Embedded FlashROM Characteristics" section were updated (SAR 32392). 2-14
8
The "Pin Descriptions and Packaging" chapter was added (SAR 21642).
3-1
Package names used in the "Package Pin Assignments" section were revised to match 4-1
standards given in Package Mechanical Drawings (SAR 27395).
The "VQ100*" pin table for A3P250 is new (SAR 31975).
4-2
The "FG144" pin table for A3P1000 was updated to remove the Flash*Freeze (FF)
designation from pin L3. This package does not support Flash*Freeze functionality. Pin
W6 of the "FG484" for A3PE600L was designated as the Flash*Freeze control pin for that
package (SAR 24084).
4-7,
4-10
Revision 3
5-3