MC9S12NE64CPVE Datasheet, PDF (275/554 Pages) Freescale Semiconductor, Inc – MC9S12NE64 Device Overview

Functional Description
Data reception is double buffered. Data is shifted serially into the SPI shift register during the transfer and
is transferred to the parallel SPI Data Register after the last bit is shifted in.
After the 16th (last) SCK edge:
• Data that was previously in the master SPI Data Register should now be in the slave data register
and the data that was in the slave data register should be in the master.
• The SPIF flag in the SPI Status Register is set indicating that the transfer is complete.
Figure 9-9 is a timing diagram of an SPI transfer where CPHA = 0. SCK waveforms are shown for
CPOL = 0 and CPOL = 1. The diagram may be interpreted as a master or slave timing diagram because
the SCK, MISO, and MOSI pins are connected directly between the master and the slave. The MISO signal
is the output from the slave and the MOSI signal is the output from the master. The SS pin of the master
must be either high or reconfigured as a general-purpose output not affecting the SPI.
End of Idle State
SCK Edge Nr.
SCK (CPOL = 0)
Begin
Transfer
End
Begin of Idle State
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
SCK (CPOL = 1)
SAMPLE I
MOSI/MISO
CHANGE O
MOSI pin
CHANGE O
MISO pin
SEL SS (O)
Master only
SEL SS (I)
tL
MSB first (LSBFE = 0): MSB
LSB first (LSBFE = 1): LSB
Bit 6
Bit 1
Bit 5
Bit 2
Bit 4
Bit 3
Bit 3
Bit 4
Bit 2
Bit 5
t_L = Minimum leading time before the first SCK edge
t_T = Minimum trailing time after the last SCK edge
t_I = Minimum idling time between transfers (minimum SS high time)
t_L, t_T, and t_I are guaranteed for the master mode and required for the slave mode.
Bit 1
Bit 6
Figure 9-9. SPI Clock Format 0 (CPHA = 0)
tT tI tL
LSB Minimum 1/2 SCK
MSB
for t_T, t_l, t_L
In slave mode, if the SS line is not deasserted between the successive transmissions then the content of the
SPI Data Register is not transmitted, instead the last received byte is transmitted. If the SS line is deasserted
for at least minimum idle time (half SCK cycle) between successive transmissions then the content of the
SPI Data Register is transmitted.
MC9S12NE64 Data Sheet, Rev. 1.1
Freescale Semiconductor
275