W90P710CD Datasheet, PDF (449/552 Pages) Winbond – 32-BIT ARM7TDMI-BASED MCU

W90P710CD/W90P710CDG
31
30
23
22
15
14
7
6
BDLAB
DIR
29
21
13
5
NSBE
28
27
RESERVED
20
19
RESERVED
12
11
RESERVED
4
EPE
3
PROT
26
25
24
18
17
16
10
9
8
2
CDP
1
0
Reserved Reserved
BITS
[31:8]
[7]
[6]
[5]
[4]
[3]
RESERVED
BDLAB
DIR
NSBE
EPE
Protocol
DESCRIPTIONS
-
Baud rate Divisor Latch Access Bit.
When this bit is set to a logical "1", users may access baud rate divisor (in
16-bit binary format) through divisor latches (BLH and BLL) of baudrate
generator during a read/write operation. A special Smart Card ID can
also be read at base address + 8 when BDLAB is "1". When this bit is set
to "0", accesses to base address + 0, 4 or 8 refer to RBR/TBR, IER or
ISR/SCFR respectively.
DIRect convention
When set as a ‘0’ or ‘1’ will receive data in the direct convention or
indirect convention manner respectively. In other words, the controller will
need to have this bit set to a ‘1’ if the first byte of the ATR process is 3F
(i.e. Indirect convention) and a ‘0’ if the first byte is 3B (i.e. Direct
convention).
Silent Byte Enable.
Receiver detect the data byte, parity bit and stop bit are all zero
Even Parity Enable.
This bit is only available when bit 3 of SCCR is programmed to "1". It
prescribes number of logical 1s in a data word including parity bit. When
this bit is set to "1", even parity is required for transmission and reception.
Odd parity is demanded when this bit is set to "0".
In contrast to its UART counterpart, Smart Card Control Register only
controls parity bit setting because data length is fixed at 8-bit long for
Smart Card interface protocol.
Protocol.
Bit PROT is set if the protocol is T = 1 (asynchronous) and bit PROT = 0 if
the protocol is T = 0.
Publication Release Date: September 19, 2006
- 449 -
Revision B2