W90P710CD Datasheet, PDF (193/552 Pages) Winbond – 32-BIT ARM7TDMI-BASED MCU

W90P710CD/W90P710CDG
Continued.
BITS
[3]
CPS
[2]
SPS
[1]
SPE
[0]
DRM
DESCRIPTION
(Read) PortOverCurrentIndicator
table of none-2 supports global over-current reporting. This bit reflects the state
of the OVRCUR pin dedicated to this port. This field is only valid if
NoOverCurrentProtection is cleared and OverCurrentProtectionMode is set.
0 = No over-current condition
1 = Over-current condition
(Write) ClearPortSuspend
Writing a '1' initiates the selective resume sequence for the port. Writing a '0'
has no effect.
(Read) PortSuspendStatus
0 = Port is not suspended
1 = Port is selectively suspended
(Write) SetPortSuspend
Writing a '1' sets PortSuspendStatus. Writing a '0' has no effect.
(Read) PortEnableStatus
0 = Port disabled.
1 = Port enabled.
(Write) SetPortEnable
Writing a '1' sets PortEnableStatus. Writing a '0' has no effect.
(Read) CurrentConnectStatus
0 = No device connected.
1 = Device connected.
NOTE: If DeviceRemoveable is set (not removable) this bit is always '1'.
(Write) ClearPortEnable
Writing '1' a clears PortEnableStatus. Writing a '0' has no effect.
USB Operational Mode Enable Register
This register selects which operational mode is enabled. Bits defined as write-only are read as 0's.
REGISTER
ADDRESS R/W
DESCRIPTION
RESET
VALUE
OperationalModeEnable 0xFFF0_5204 R/W USB Operational Mode Enable Register
0x0000_000
0
Publication Release Date: September 19, 2006
- 193 -
Revision B2