W90P710CD Datasheet, PDF (131/552 Pages) Winbond – 32-BIT ARM7TDMI-BASED MCU

W90P710CD/W90P710CDG
Transmit Start Demand Register (TSDR)
If the Tx descriptor is not available for use of TxDMA after the TXON of MCMDR register is enabled,
the FSM (Finite State Machine) of TxDMA enters the Halt state and the frame transmission is halted.
After the S/W has prepared the new Tx descriptor for frame transmission, it must issue a write
command to TSDR register to make TxDMA leave Halt state and contiguous frame transmission. The
TSDR is a write only register and read from this register is undefined. The write to TSDR register has
took effect only while TxDMA stayed at Halt state.
Register
TSDR
Address R/W Description
0xFFF0_30A0 W Transmit Start Demand Register
Reset Value
Undefined
BITS
[31:0]
Reserved
DESCRIPTIONS
-
Receive Start Demand Register (RSDR)
If the Rx descriptor is not available for use of RxDMA after the RXON of MCMDR register is enabled,
the FSM (Finite State Machine) of RxDMA enters the Halt state and the frame reception is halted.
After the S/W has prepared the new Rx descriptor for frame reception, it must issue a write command
to RSDR register to make RxDMA leave Halt state and contiguous frame reception. The RSDR is a
write only register and read from this register is undefined. The write to RSDR register has took effect
only while RxDMA stayed at Halt state.
REGISTER
RSDR
ADDRESS R/W
DESCRIPTION
0xFFF0_30A4 W Receive Start Demand Register
RESET VALUE
Undefined
BITS
[31:0]
Reserved
DESCRIPTIONS
--
Maximum Receive Frame Control Register (DMARFC)
The DMARFC defines the maximum frame length for a received frame that can be stored in the
system memory. It is recommend that only use this register while S/W wants to receive a frame which
length is greater than 1518 bytes.
REGISTER ADDRESS
DMARFC 0xFFF0_30A8
R/W
R/W
DESCRIPTION
Maximum Receive Frame Control
Register
RESET VALUE
0x0000_0800
Publication Release Date: September 19, 2006
- 131 -
Revision B2