MC68HC912DG128 Datasheet, PDF (364/452 Pages) Motorola, Inc – Microcontrollers

Freescale Semiconductor, Inc.
Development Support
The external host should delay about 32 target BCLK cycles after the
data portion of firmware write commands to allow BDM firmware to
complete the requested write operation before a new serial command
disturbs the BDM SHIFTER register.
The external host should delay about 64 target BCLK cycles after a
TRACE1 or GO command before starting any new serial command. This
delay is needed because the BDM SHIFTER register is used as a
temporary data holding register during the exit sequence to user code.
BDM logic retains control of the internal buses until a read or write is
completed. If an operation can be completed in a single cycle, it does not
intrude on normal CPU12 operation. However, if an operation requires
multiple cycles, CPU12 clocks are frozen until the operation is complete.
18.4.4 BDM Lockout
The access to the MCU resources by BDM may be prevented by
enabling the BDM lockout feature. When enabled, the BDM lockout
mechanism prevents the BDM from being active. In this case the BDM
ROM is disabled and does not appear in the MCU memory map.
BDM lockout is enabled by clearing NOBDML bit of EEMCR register.
The NOBDML bit is loaded at reset from the SHADOW byte of EEPROM
module. Modifying the state of the NOBDML and corresponding
EEPROM SHADOW bit is only possible in special modes.
Please refer to EEPROM Memory for NOBDML information.
Technical Data
364
MC68HC912DG128 — Rev 3.0
Development Support
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA