C8051F80X_14 Datasheet, PDF (52/251 Pages) Silicon Laboratories – Mixed Signal ISP Flash MCU Family

C8051F80x-83x
SFR Definition 8.4. ADC0CN: ADC0 Control
Bit
Name
Type
Reset
7
AD0EN
R/W
0
6
AD0TM
R/W
0
5
4
3
AD0INT AD0BUSY AD0WINT
R/W
R/W
R/W
0
0
0
2
1
0
AD0CM[2:0]
R/W
0
0
0
SFR Address = 0xE8; Bit-Addressable
Bit Name
Function
7 AD0EN ADC0 Enable Bit.
0: ADC0 Disabled. ADC0 is in low-power shutdown.
1: ADC0 Enabled. ADC0 is active and ready for data conversions.
6 AD0TM ADC0 Track Mode Bit.
0: Normal Track Mode: When ADC0 is enabled, tracking is continuous unless a con-
version is in progress. Conversion begins immediately on start-of-conversion event,
as defined by AD0CM[2:0].
1: Delayed Track Mode: When ADC0 is enabled, input is tracked when a conversion
is not in progress. A start-of-conversion signal initiates three SAR clocks of additional
tracking, and then begins the conversion.
5 AD0INT ADC0 Conversion Complete Interrupt Flag.
0: ADC0 has not completed a data conversion since AD0INT was last cleared.
1: ADC0 has completed a data conversion.
4 AD0BUSY ADC0 Busy Bit.
Read:
Write:
0: ADC0 conversion is not 0: No Effect.
in progress.
1: Initiates ADC0 Conver-
1: ADC0 conversion is in sion if AD0CM[2:0] =
progress.
000b
3 AD0WINT ADC0 Window Compare Interrupt Flag.
0: ADC0 Window Comparison Data match has not occurred since this flag was last
cleared.
1: ADC0 Window Comparison Data match has occurred.
2:0 AD0CM[2:0] ADC0 Start of Conversion Mode Select.
000: ADC0 start-of-conversion source is write of 1 to AD0BUSY.
001: ADC0 start-of-conversion source is overflow of Timer 0.
010: ADC0 start-of-conversion source is overflow of Timer 2.
011: ADC0 start-of-conversion source is overflow of Timer 1.
100: ADC0 start-of-conversion source is rising edge of external CNVSTR.
101–111: Reserved.
52
Rev. 1.0